6031/4VBF53 Thrust Bearing 6031/4V Full Complement Of Balls, Case Hardened Carbon Steel, 0.5000" Bore x 1.0000" OD x 0.3440" Width

Hard to find thrust bearing for my Harley wheel bearing removal/installation kit. Unfortunately the I.D. was slightly too small for my installation bolt, so I had to go up one size.Comes pre-oiled to prevent rust on the carbon bearings. Make sure to shmear some wheel bearing grease into the ball bearing slot before using.I received one bearing, not a box of 10, so it was a bit pricey. However, the next size up that I also purchased came with a box of 10...go figure.

American made precision. Just grease and go. Very NICE of seller to throw in a few extra ones.

Got this bearing to replace a bad one in a farm implement tongue jack. It fit fine, and works well. Not 'quite' as stout as the Bulldog brand, but for all but the heaviest loads, it should be more than fine.

It worked as it should.

I have an old lathe. It needed a bearing that is the same as this one. I thought I was getting 1 for 10 dollars but I got a box of 10!! Greased it up and put it in. Works great!Now I can keep this lathe going for another couple dozen years!

Bought this thought I was getting one for 5.58 but was honestly surprised to find a box of ten at my door step. Idk if this was a mistake? But should last me years to come.

made is Usa

Good price, brand name as advertised, and spins but not too much, which is also a sign of bearing wear.