foil foam mat

Works great! Great value! I used this to insulate around my window air conditioners that overlook a NYC street. I wanted sound and temperature blocking and this works great. The adhesive is strong, so you can't relocate it after it's been pressed into place. Removing it leaves a this layer of foam which takes some elbow grease to remove. It was easy to cut and install then it stays in-place. It does a great job blocking noise.

This material worked out perfectly for my 98' Toyota Camry and looks great! Simply roll out the new insulation material then place your old hood insulator over it (pick any corner) and trace around the old hood insulator and make marks to cut for engine labels and little dots for aligning the plastic hood retainers. My 98' Camry takes 11 hood retainer clips. I dropped one into the engine bay and lost it LOL so ten will do. The adhesion sticks instantly to the hood, so keep this in mind. When you're done with the cut-outs and are ready to apply it to your hood, I recommend using a spray bottle with rubbing alcohol and spray down your hood and use some paper towels to clean it. Peel half of the paper from the adhesive side back and apply it slowly while aligning and placing in your hood clips aswell. I recommend doing this during warm weather, so the adhesive makes the right stick. I am pleased with this product the hood on my vehicle is cold to the touch; at most it's a tad bit warm if anything! The material does provide sound deadening as well, which I've noticed when the car is idling. I would highly recommend this product over your cars OEM hood insulator. I went to find out the price of my cars OEM hood insulator, and they wanted $260 for it. Psst! Forget that! This insulation material worked just as great for a replacement!

I was referred to this product through the vanlife Facebook group. This is my third purchase of this product for use in my camper van. It is cheaper than the square sound dampening panels that you roll to adhere. And these have the added benefit of being insulative. I converted a minivan and used this on all the outer wall surfaces and in my trunk space before adding another layer of Havelock wool insulation. I noticed an effect right away after I had gutted the interior of my van down to the bare metal. Hardly any road noise and no 'jingling' could be heard while driving even prior to building out the interior. Definitely recommend for all my fellow van-lifers! One tip... make sure you wear gloves when applying this. The adhesive is super strong it's a pain to remove it from your bare skin!

This product is pretty nice for the cost. The adhesive is surprising good. When you first time you feel it, it doesn't seem like it's very strong, but it sticks very well. The paper comes off fairly well, but tears easily, so you might need to pick it apart a little bit. This material is really designed for temperature insulation and not noise insulation. I wanted to try it out after seeing so many reviews about using it for sound insulation, so I bought 5 rolls to apply to my Geo Metro. I laid down some vibration dampener first and then did complete coverage on the floor from the firewall to the trunk. I had about 70% of one roll left, so a normal sized was will probably require 6 or more rolls. I had doubts about using this for sound control because it is just a foam material; there is no weight to this product, so blocking any low frequency sound was out of the question (road noise, exhaust or tire noise). If you paired this product with something like MLV, you might get good results, but this material is a 1/4 inch thick, so you wouldn't have room to apply it with another barrier. The result? There was a reduction in wind noise, but the exhaust and general road noise were unaffected. I still think this is a quality product, but you need to make sure you're using it for the right application. I knocked a star because it was marketed as a sound deadening material. If you want good sound control, I would suggest using 25% coverage with a vibration dampening material (Dynamat, fatmat) and then 100% coverage with a two-in-one closed cell foam and MLV product like Second Skin Luxury Liner Pro.

Purchased twice. Used as boat engine compartment insulation and rear cabin wall insulation in my 2019 Ram truck. Worked well in both applications.

Squrrels destroyed original underhood insulation mat on my friend's car and she asked me to help to replace it. I checked prices for OEM part, it was too high. I looked for another solution and found this mat. It cost $36, not few hundreds. With the adhesive backing it was very easy to install. It has good temperature and noise insulation. Now after 3 years it still looks like new and squirells don't touch it. My friend is really happy with it.

I ordered two of these last year for my jeep cj7 and had a roll left so been using this around the house! well I just ordered two more! I insulated my attic pull down which is in air conditioned laundry room and testing before and after with temp gun its night and day difference. so I have a old screened in porch outside my kitchen and it has a flat roof and the wall to kitchen was showing 82 degrees on inside so I covered part of the wall outside and now the inside wall shows 78 which is what thermostat is set too. This stuff is the bomb! and the adhesion is great! as long as the surface is clean! it worked great in Jeep as far as heat on floor do not know about sound as I have no doors on jeep.

Have not installed yet but not straight on the ends so will have to cut in straight just to start and it is ALREADY Short??? 4 and 3 inches both ways??? A Good company will ALWAYS give you a little extra for your projects, so tells me a LOT about this company.....Looks like a decent product, thick and seams tough enough, but very badly wrinkled on foil side, came folded not in a roll as any Good company does with anything that needs to be flat as the manufacturer intended!!! Rating not based on performance. Now the rating about some of the performance. The sticky side is NOT very sticky and the adheasive part comes right off so won't stay down. where I used it I tucked under areas where I could and that helped also I use several layers and that helped keep it down. Works very well for sound deadening just needs better adheasive and on a roll as their Pictured Ad Shows, NOT Folded!!!

I bought the product to try and cut down on heat and noise coming through the engine cover of my motorhome. Easy to install and works great.

Second roll i have bought to finish the trunk of my car, this worked great and was easy to apply and sticks good. improved my sound quality quite a lot, Thank you.

easy to install. stick very well. I put 2 layers for my sail boat engine compartment. Keep heat and sound low, Good improvement from before.

Pretty good insulation, good adhesive, fairly rugged. Used it to line RV storage bins

This is really effective and weight almost nothing. Easy to install and stay in place. I would buy again with no problem