316 Stainless Steel 1/8"~3" Full Port Ball Valve with Blue Vinyl Handle, NPT Female x Female Thread,1000 WOG (1")

Works time will well tell . said was stainless steel already has some rust on fittings.

Replaced the PVC valves with this stainless... it was quite a bit moremoney but I am constantly using it out at the pool. It is solid and well worth the money if it is opened and closed a lot.

Good valve for high pressure systems with lots of valve switching use, holds up to 200psi oil, fuel, and air, saves $20 per valve compared to brass, I've used 10 of them in various sizes

It came as a 2 pack. I used one immediately and it worked fine. When I went to install the other one it immediately began to leak. It had a small pinhole in it. It is a casting flaw I presume.

I water my garden using IBC containers. The ball valve handle at the bottom of one of my containers snapped off, so I used this valve as a screw on replacement. It does fit my tank but it is leaky even with Teflon tape. Probably 3 drips per second. Ideally I would’ve preferred it not leak at all so that I can fill my tanks and leave them full so they will last until a day that the garden needs water. In this scenario, I have to fill them on the evening I plan to water. In that case, the valve restricts the water enough to be useful. And it helps that I can directly connect my 2” draft hose for my harbor freight water pump so that I’m pulling from the bottom rather than the top. All things considered, I will order another for my non-broken tank just so that I can draft from the bottom and maximize my watering. I would not buy this if it was for plumbing indoors where leaks really do matter more.

So far this is working perfectly. I grabbed a brass nipple to thread from this into my tank and a NPT to hose adapter so I can drain the water easily. Once the valve is opened the flow is awesome and I am now able to get a ton of crud out of my tank instead of letting it all sit in the bottom and cause issues. If you want your water heater to last longer you gotta flush that junk out and sadly the valves they include from the factory are only meant to allow you to slowly drain things. Even if my tank starts to go bad down the road I will be able to install this valve right away and have a tank that will last for years beyond it's rating.

Product was exactly what I needed. Used in sprinkler pump piping. Great quality and sealed

At the Home Depot does not even available for 1.5" valve. And the 1.1/4 is almost $30 a piece, this one is $30 for 2.

I purchased this valve for a diesel slip tank. It was meant to isolate the fuel from the transfer pump if it needed to be replaced,but it leaks and is inadequate.

Holaaa. Se ven muy buenas. Muy residentes!!!!