Housings are made from 14 ga. (.080"), steel. Each has a 7/16" wide ledger that hooks under the cabinet. This ensures the load gets carried directly on the leveler, not the screws. Included are 3/4" long #10 Philips head (nickel plated). Versatile Threaded Leg The legs have a 10mm dia. (a heavy 3/8") shaft that adjusts from 0" to 2-1/2". The feet are 1-1/4" dia. and spin freely on the threaded shaft. This allows them to tilt if your floor is uneven. Adjustments are easier too, as you won't be fighting the friction of the entire foot rubbing against the floor as it's being turned. Black polyethylene caps protect your floor and block any moisture from getting to the foot. Hex Nuts Included. These are a MUST for the workshop or garage, especially if vibrating equipment is involved. Just level the piece out and then snug the nuts up against the bottom of the housing. Installation. Just hook them onto the cabinet and attach with the provided screws. The whole thing could be done in 5 minutes. Adjustment If you're able to reach below, it's easiest to just use a pry bar to lift the cabinet and turn the shaft with your fingers.. An access hole can also be drilled in the cabinet floor to get the wrench through. Here's what you get... - 4 Heavy Duty Leg levelers - 16 Pan head screws (#10 x 3/4") - 4 polyethylene caps- 4 1.5 inch felt pads- 4 10mm hex nuts
Trustpilot
2 months ago
1 month ago
