Question 1

I know it mounts to the column, not the fence. The question is if you use a fence on a drill press table will the fence block the laser light?

Accepted Answer

It depends on the location and height of the fence.  A vertical fence (running from to back) to the right or left of the drill bit or a horizontal fence in front of the bit are no problem. A horizontal fence behind the bit can block the laser if the fence is much taller than the workpiece being drilled.  I have had the drill press laser only short time but the only problem I see so far is you have to make sure to turn off the laser to preserve your batteries.

Question 2

Does it come with the extender plate that allows the laser to be installed further away from the column as shown in user photos?

Accepted Answer

Mine came with everything I needed to install the lasers and line them up with the drill bit. Wait, I did have to use my own screw driver.

Seriously - it you wanted more space between the column and the laser mount you could easily make a spacer to move it farther out. But mine fit just fine with only what was in the package.

Question 3

Will it work on a 25mm diameter column?

Accepted Answer

This is the contact email address ( digital@wixey.com ) for wixely.com. They have no listed phone number so email is their only contact method so email them and ask them if their model WL133 Drill Press Laser will fit on a 25mm or 0.984252" or approximately 1" diameter column without modification. My drill press column is 2 1/2" in diameter and the laser fits it without any modifications. The only possible modification that may be required is to decrease the spacing between the two holding pins so they both come into contact with the 1” diameter column.  I don't know what level of accuracy you require but using the Wixley method of alignment the best I could achieve was cross line point accuracy of 0.1". However, when drilling very very small diameter holes that level of accuracy is not good enough so I used a more sophisticated method of aliening the laser lines and achieved a level of accuracy of 0.05" which works for my application. Unless you have a real need for this increased level of accuracy it would serve no practical purpose because a 0.1" level of accuracy works just fine for most drilling applications. Again, you can contact Wixley by email at ( digital@wixley.com ) and ask them if it will fit a 1" diameter column or if it would require modification to fit correctly, I simply don't know.

Question 4

Does the laser lines blur if the table is lowered? I'm really talking about the crispness of the lines.

Accepted Answer

They really don't get much wider within reasonable distance to the work.  However, they are not quite as crisp as one would wish them to be.  Also I have suggested to the manufacturer that  they use different colored lasers for the two to make the crossing more visible.

Manufacturer	Wixey
Part Number	WL133
Product Dimensions	20.32 x 15.24 x 22.86 cm; 453.59 g
Item model number	WL133
Colour	Black
Material	Steel
Power Source	Corded Electric
Voltage	2.5 Volts
Item Package Quantity	1
Special Features	Durable
Included Components	2 AA batteries
Batteries included?	No
Batteries Required?	No
Battery Cell Type	Alkaline
Item Weight	454 g

WixeyWL133 Easy Mounting Drill Press Laser, Precision Measurement Marker Battery Operated

Details

Description

Specifications

Have a Question? See What Others Asked

Common Questions