Rear Middle Window American Flag Decal Fits Dodge RAM 2019+

Top et bien cool.Très bonne qualité.

I wish I had looked closer. This flag has only 36 stars. Where did the rest of the states go??? Next issue was the overlay was not cut straight so the flag was a little crooked on the window. Flag must be made in China because in the USA you would think they would know there are 50 stars.

So I really don’t review stuff in here but I felt like it would help others. Read the instructions! Again, read the instructions! Before you open the package, read the instructions. I would honestly suggest to read many of the tips from others on here and do not be discouraged by the folks that had a difficult time. You MUST take your time in installing this.Clean your window thoroughly with winded or other glass cleaner. I cleaned it multiple times to ensure a proper clean and no oils or dirt remained. I didn’t used any alcohol but my cleaner already has it in there.One thing to note is that the backing film was vertically cut and not horizontal as pictured in the instructions which to me made no difference (take your time). I peeled the backing off from the center out to the right (away from the stars). Peel only a little and use the squeegee to smooth out the vinyl onto the glass. Inch your way across ... peel, squeegee, peel, squeegee, etc. then start on the left side, peel from the middle out to the left towards the stars. Same process, peel, squeegee, peel, squeegee, etc. once the backing is off, it should adhere to the glass.DO NOT peel the masking tape off right away!! Big no no. Squeegee all parts of the Stars and Stripes. For each stripe I squeegeed up and down to ensure all bubbles got out. Do the best you can for the stars. THEN use your thumb or finger and press hard along all of the edges and the stars and around the entire border. When you’re ready, peel one corner very slowly, I did this from the bottom left but it shouldn’t matter. Take your time and peel it off slowly. As soon as you see a bubble, out the mask back down over it and the squeegee the bubble out. Do not squeegee the vinyl directly as you may damage it. Once the whole thing is off, gently smooth it out with your fingers (avoid using your nails).Good luck!

Shipping was a little slow but no complaints. After reading some reviews, I was debating whether to purchased this. But after installing, I it was a piece of cake. You have to be a real idiot to screw up the install. A monkey can install this. Product as described, perfect fit, took about 4 minutes to install. You really have to be patient and use the plastic scraper to press down and get all the bubbles out. If it doesn't adhere in the corners, just press more on the masking back and guide the scraper till it does stick. I used just a little heat from a blow dryer to hard to stick corners since it's about 27* in my garage. Works well, fits perfect. Looks great on my new 2020 truck. Pictures attached.

I was excited to put this on my brand new 2020 Ram 1500. However, this product didn't serve me well which is really disappointing. You see, my Ram is the 'Built to Serve' edition and it has two US flags on the rear quarter panels which I thought this flag decal would match well with the theme of the truck. I followed the directions to a tee. I used a degreaser and followed it with alcohol right after a wash. The decal wouldn't stick whatsoever. After several attempts, I discovered that the stripes of the flag are actually individual stripes which made it difficult to peel and stick onto the glass so you could make the whole flag adhere just in case it doesn't stick. All I want to say is it didn't work for me. I'm sure many buyers didn't have any problems. Another thing, my decal peeled from side to side, not from bottom to top like the directions show. I don't think that makes a difference but maybe it can pin point the problem to a production run of these stickers. Anyways, I posted a picture of my frustration of this product. Good luck on your experiences.