GoYonder 50 Pack 4.5" Cutting Wheel for Metal,Stainless and Steel 4-1/2" x 0.045 x 7/8-Inch Ultra Thin Cut-Off Wheel for Angle Grinders

I usually buy Harbor freight discs but I could not pass up the excellent price so I gave them a try. They work great and I didn't notice that they wear any different than the ones I am used to. If you are rough with them and pinch then in the cut they do break but then again any disc will do that. the benefit of these discs is a slightly thinner kerf which is easier on my tool. I will definitely purchase them again.

These wheels cost half the price of home improvement warehouse products and perform just as well. They are very thin, so care must be taken not to bind them or they will shatter, but we cut steel pipe and plate with them and they do fine.

Used it to cut 3" and 4" galvanized pipe. Cut quickly, probably because they are on the thin side, did not break, and lasted as long as any abrasive type cutting wheel. Would purchase again.

The first pack was great but the second pack 4 out of 5 wheels loose their center mounting ring on the first usage full disk and broken. A broken cutoff wheel can cause alot of damage I had a chunk come off and stick in my leg 12 stitches and back to normal but if you can't tell if a pack is safe to use they are not worth the money

Definitely don’t last as long as higher quality cut off wheels but for the money I don’t really notice it.

I still have a lot of my old discs, so I haven't used any of these yet. They arrived as scheduled without incident, packaged well, appear to be fair quality discs. No problem with the company or its service. I have little doubt they will serve well when the time comes.

I have used a lot of cut off wheels this wheel if you hold it steady it will cut and will not shatter like most Wheels

i bought these because of delivery time. that being said i wouldnt buy again better to pay more and wait longer for delivery

This product in my opinion is dangerous I have been using angle grinders and high powered hand tools for over 50 years so know all the ins and outs, I just done two cuts with one of these blades on third cut the blade just snapped,Sent fragments of it flying out I was wearing goggles and a mask so was ok but one section just missed my head, so if you using them be extra careful or better still throw them away and spend a bit more on decent ones,see photo I was just cutting thin metal angle iron so not really a hard thing to cut ....

I needed to remove some old metal wire fencing and these were perfect for the job. Perhaps a little thin for some of the bits I was cutting, in which case they wore down fast, but that was to be expected. Thin, cut fast, didn't splinter or shatter. Used with a Makita LXT cordless angle grinder, fit no problem.

starts to degrade quite quickly in use, however im not experienced with different disk brands or how long they should last. They still hold up well and I managed to cut everything I needed to and still have 7 spare disks. Cuts well and makes light work of most materials.

I am pleased with the discs. I do use them daily at work. They do break easily if you’re not careful whilst storing if kept on the disc cutter and not in the carry case. They cut really well though.I would definitely recommend and also buy again.

I brought these to cut through tin roofing, brilliant. Great value for money, worn the same as the expensive brands. Really pleased. And still have half left, I have cut 14 sheets, and 2 were length ways.