D-Lumina Mud Flaps Compatible with Toyota Tacoma 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 - with OEM Fender Flares Only - Heavy Duty Front&Rear Mudflaps Splash Guards, 4Piece

Very easy to install, overall 30-45 minute job. 2 different plastic clips holding fender liner, one being the usual remove with flat head and the other being needing a trim removal tool to pry out(force needed) the clips with circles in the middle. Front guards utilize factory hardware. Rear guards need more work done, 10mm bolt screw holding in along with usual plastic clips. Upon installing rears use factory 10mm bolt for bottom but switch to provided plastic clips for inside fender. Use small metal clips on rears, slides right over factory fender to provide backing for 1 of the 2 screw holes being the one higher up. Both rear pieces utilize 2 screws just have to screw through the liner, force is needed.

These are pretty nice for the money half the price of the others however I did not want to put holes in my fenders. I had to put screws through my fenders to install these according to the instructions I was not supposed to have to do that!fenders in case I did not like them. In the ad it says no drilling to me that means I don’tYou will have to add new holes for screws into your fenders for this have to put any extra holes that it will go into the holes that are already there with the screws already there that’s not true I had to putScrews in all the holes except for two in the front flaps. That’s why I give a three star

I just bought a new 2020 Ram 1500 Classic Warlock and have spent most of the week shopping for and installing the must-have accessories. After the bed liner, tonneau cover, wheel locks and brake controller, there was no way I wanted to spend 100 bucks on mud flaps. These were the only other no-drill option and they were half the price. I bought them and I am so glad I did. They fit perfectly against my fender flares and each flap used two of the factory screws to mount. Hole alignment was good. I didn't end up needing the included hardware. I recommend not tightening either screw before you get them both started. A deal at 49.95!

The instructions were useless, look up husky videos to know how these install without drilling. The push pin replacements for the rear Christmas tree plugs don't fit at all, luckily I have a ton of different sizes in my toolbox. The fronts are held on by a couple pieces of 3m and 2 clips that are a pain to get on. I used a third clip near the inner bolt for a little more security but may eventually just do some drilling

Rear flaps installed with no drilling and factory screws. The front flaps i installed with stainless steel zip screws with washers and put a dab of black metal paint on the heads. They look and function great and are very good quality.