Magigoo Pro PA - The 3D printing adhesive for Polyamide (nylon) (50ml)

Der Kleber funktioniert richtig gut, allerdings ist er für große drucke mit PA bei nicht ausreichender Bauraumheizung immer noch zu schwach. Bei Ausreichender Bauraumheizung funktioniert es allerdings sehr sehr gut.

Prodotto acquistato per problemi di adesione con nylon PA12. Molto facile da usare, si pulisce il piatto poi si stende il prodotto e si lascia asciugare 10 minuti (per una migliore finitura superficiale del pezzo, dopo aver steso il prodotto, ho usato un pennello con setole molto sottile e morbide). Con piatto caldo l’adesione è tenace. Finita la stampa a piatto freddo (circa 25 gradi) si è staccato con una leggera pressione. Forse l’unico neo il prezzo un po’ alto.

I tested the Magigoo Pro PA against my existing 3DPrima PrimaFIX glue for Sirayatech PPA and PPA-CF Core filaments and Sunlu PA6-GF25 on a Bambu Lab P2s Engineering plate heated to 100C and a build chamber temperature of 55 at the start of printing, rising to 63-65C. I did not test any other build plate temperatures. Comparing the consistency, the Magigoo Pro PA has a lower viscosity and is clearer when applied, leaving no bubbles, while the PrimaFIX is milky to begin with and leaves a few bubbles but these disappear and the film turns completely transparent once heated up on the bed. Both wash off completely with washing up liquid and hot water. The PrimaFIX provided significantly greater adhesion for all filaments even after 4-5 prints without reapplication. This could be a good thing or a bad thing. If your parts are prone to warping and require very strong adhesion, go with PrimaFIX. If you want to be able to easily remove the parts, and potentially minimise wear on your build plate surface, go with Magigoo Pro PA. I myself will continue using PrimaFIX, which is less than half the price.

fait parfaitement le job pour du PA, j'achèterais la version ABS par la suite pour comparer.

高いだけあって効果に嘘はありません 但し、高価なのでまずはシワ無しピットで試してダメな時の最終手段として買うのが良いかな