North American Arms Boot Grips GBGM GBGM

Really liked fit perfect

I bought these for my North American Arms 22 mag mini-revolver. They offer a much more substantial grip than the original ones. Plus, I like the "Western" look that they give the gun. Earlier I had purchased the black, rubbery Mini-Master grips. Although they did improve the overall control while shooting, I didn't care for the look of the gun with them on it. I really like the boot grips. They provide the same additional mount of control when shooting and they look "smart" on the gun.

I bought these for the NAA Wasp. The factory grips are okay, but leave a lot to be desired. These boot grips take the accuracy and handling to a whole new level. I used to have to roll my wrist forward to quickly get a decent sight picture, but with these grips being slightly longer (probably just under an inch longer) and thicker, the weapon points naturally and less thought is put into sight alignment. It almost feels like you are holding a smaller version of the Ruger single six for a rough comparison. If you want to use something like the Wasp or similar as a self defense weapon and can spare to carry a slightly bigger profile, these grips actually make the Wasp a more viable option in terms of shootability and handling. I would definitely recommend these grips and will be ordering another set if I buy another NAA.

Fit good and looks good

He's fit nice but they're slippery but I used a adhesive grip paper that you can cut to fit and I put it all the way around the handle which gives it a nice grip. So I ended up covering up all that nice pretty wood anyway because it's just too slippery but it is a nice little handle. They should just make a rubber one that has some grip on it and forget about the wood grain

Perfect fit for my 22mag. Great quality and look. Highly recommended

require a bit of dremel work to get them to fit tight..not much, but it must be carefully done. The underside has a milled edge that fits the inside of the frame..just a bit too wide to fit flush so a small amount of trimming is necessary..It came with a new screw and two metal pins...secure and very good looking grips and man do they change the appearance ..wow..a worthy upgrade ..expensive little grips, but worth it...

Downright ugly and became expensive dust collector. Would be fine if you don’t mind bulky and doesn’t look like it was made for this gun but fits just seams don’t match