Iverntech 42 Nema 17 Stepper Motor 60mm Body 1.8 Stepper Angle 1.5A 2 Phase 4-Lead with 1M Cable for 3D Printer, CNC Machine and Robotics

Quality

Brought as part of a large project, so not fully tested yet. I have tested it on a stepper motor tester and it does exactly what you'd expect a stepper motor to do

Installed as a light weight direct drive extruder motor and is working well. Nice that it comes with a 1 meter cable too.

Like the fact it has flat sides so the grub screws grip but don’t like the fact I had to change the pins around on the motor end of the wire to make it work correctly

Used this to replace the Y Axis Motor on my CR10 - S5. It fitted perfectly but does need the centre pins swapped as the seller states. I reused the Creality cable and if you are careful you can remove and reinsert the pins by lifting the white retraining clips with a small screwdriver. It has been running for a couple of hours now and is perfect.

Used this for a disco ball strong motor good control using a 3rd party circuit board.

These motors are not compatible with ender printers, unless you swap wires over. This isn't a simple thing to do, and the extension cable has no facility for you to do this without the risk of breaking something.

Used to replace a faulty Motor on My DIY CNC router. Great quality and you can clearly hear the difference from the original…..

Non è adatto per l estrusore perché tende a scaldare troppo.

Ottimo motore in sostituzione dell'originale su una Anycubic Predator ..non servere invertire i fili perchè il cablaggio è già giusto...per la durata vedremo.

ottimo prezzo, funziona

Passt alles

ok