Kinstecks 2PCS LED Flash Strobe Controller Brake Light Flasher Brake Light Strobe Module for Motorcycles Cars Trucks(Only for LEDs)

I needed to purchase these for my track MX5 NC car, fitting was easy, cabling length is good. Easy to install, no instructions provided but non really needed. Flashing is very instant, does a good few flashes and then goes on solid which is perfect to just grab other drivers attention

Right, I seen a lot of reviews saying don't work if lights are on all time etc. I have a 04 bike and had same issue what I found was connect red wires in line of brake wire and the 2 black wires to bikes earth but not in the loom I did it at earth point to frame and it started to work. I also changed my bulb to led. The issue you have is due to most bike only have 1 earth going to back of bike by cutting into it and fitting this unit in line you end up removing the earth which is what I found out. Hope this helps others 🙏

Has anyone fitted this to there car and when the ignition is on its works fine and then when you start the car it just flashes rapidly fast that fast that the light isn't bright at all instead of doing 4 fast 4 slow then solid any help would be appreciated if you can even comment on this 👍

So, I have received my 2 controller and tested them today. First one : not working at all. Second one : working but no flashing just always ON. Waste of time, money, packaging and resources. Stay well away.

Doesn't work properly very often, break light just flashes like crazy.

I dislike as my money gone and doesn’t work

Dislike product due to not working as it should it dims out the light once installed

One unit worked as it should, the other did not flash the lights at all.

🤩

Installé sur une Tesla performance et un Kawasaki Z900 RS SE.

It working and functioning as promised and it does it well! It strobes first fast then slow and it finish with steady light. I tested it with 24V and both devices worked flawlessly, nice! The price is reasonable and I got a good value for my money! One remarks thought: It would be preferable if one could disable the long strobe ( just fast strobe and then steady light) when one brakes only momentary it takes to long to get steady red light! Caution! If you have a LED light with independent electronics build in, it can alter the strobe functionality! Only couple the strobe controller to LED light with no extra electronics in it for proper functionality! Hope this helps :-)

I took three LED 6" lights and attached to my trunk on my bike. the two outside lights steady burn and the center is hooked up to this flasher and activated with the brake--- gets your attention-- very easy to hook up.

Passt, funktioniert und leicht zu montieren