mxuteuk 3pcs DC12V Momentary Rocker Switch 6 Pin 3 Position DPDT Reverse Polarity Toggle Switch Automatic Reset Power Switch (ON)/Off/(ON), Use for Motor Car Auto Boat KCD2-223-JT

These have exceeded my expectations so far. Just needed one but is easy to push and works perfect. I mounted it in a truck dash that was a but curved and thick so I had to cut the clips shorter for it to snap in but install was simple then and still looks great.

Used with raspberry PI GPIO direct input with pull up resistor. I use it to control direction of stepper motors to jog them forward or backward. I debounce all switches via software, but didn't see any bounce on the switches at all.

Switches work exactly as described. Cut a couple openings into a metal double gang wall plate and slid them in. Use them to operate motorized shades.

out of the 3 switched I only have 1 that has an issue, sometimes the switch will stick in just 1 position however it is hardly noticeable as the slightest touch too it will cause it to snap back to its original position. The switch will slide into the slot with ease but will not come out unless the side pins are pressed in, this makes secured in the slot verry well.

These will be backup switches for a switching puzzle, hope I don't need them right away.

Works great

power control for motorized antenna. handles 2.5A at 12VDC ok. no problems and have worked it quite a bit with no issues. have only used one of the three so far though. (thats all i needed.)

Worst switches I have ever had. Probably less than 30 actuations and they became intermittent. I thought it was a fluke but it happened on all three