7 Inch Motorcycle Headlight Housing Bracket Headlamp Shell 7" LED Headlight Bucket Mount for Harley Suzuki Chopper Cafe Racer Bobbe Aprilia Matte Black Motorbike Headlight Bucket

Perfect fit

I bought two of these for my two ebikes and installing the headlight was the easy part in my opinion, yes it does not come with instructions, but you use the pins to secure the headlight into the housing (frame) at 4 different points, basically you put one side of the clip in the lip and slide the other end underneath of the lip 12, 3, 6, 9 o'clock positions so it can apply pressure evenly to the headlight, against the headlight housing (frame) thus holding int place. Just YouTube it and you will find videos on how, the only reason I can't give 5 is because one of them came with some scratches up on the outside, and the other one, the screw holes to, "seal" the hosing, on the bottom don't line up so one of my ebike the headlight is not "sealed" evenly across, and one housing is scratched up, But I don't plan on using my ebike in inclement weather so it still meets my needs, and would still recommend to friends if they were looking for a headlight housing for their eBike.

Ordered 2 of these bracket/housings. I say 50/50 because 1 of 2 seemed to be used or older hardware that the other. The one that seemed used had silver clips, the rubber grommet it smaller in width, and hard to get both side bolts in. The 2nd had gold clips that were tighter and fit good, rubber grommet fit perfect and was wider, all screws and bolts went in easy. Just weird that got 2 of same thing but they had little differences. Nice product though. Would buy again.

Absolutely trash, the ring that holds the light and clips is to big, it's to deep for led, the clips don't hold anything because once you get it together the light just falls back into the bucket. Very upset because I'm missing out on a big ride this weekend without a headlight.

I was originally going to return it for the reasons I disliked it but I decided to keep it and put in the extra work to make it work for my 1983 Honda Magna. It fit the forks good but the bucket was pretty shallow and only fit the light and none of the actual wires like the previous bucket did. I assumed it would at least fit the plug of the light but not even that could sit inside. The brackets don't exactly fit the bucket either so as you tighten them down they dig in and scratch the paint. Since the bucket didn't fit any of the wires I had to get a little creative on the wiring but it was hard to find a bigger bucket to replace it with. One of the brackets wasn't painted very well either, you wouldn't notice unless you really looked at it up close so it wasn't as big a problem.One thing though is it could really use a set of instructions for the clips it comes with. I think someone posted a review with pictures and that helped. Getting the light level and centered in the bucket took a few tries as well.It looks slick and great on the bike. I wish the bolts were all black too like the bucket but I could just paint it so it's not a big deal but is an after thought.

Its a great bucket. Perfect fitting for aftermarket lights, although I did have to cut the rear wire hole larger in order to get all of my plugs to fit. I had to reference the review pictures in order to figure out how to use the clips because there were NO installation instructions.Once I did get them on everything else was a breeze. Great product but be sure to come back and look at others pictures and advice on how to make it easy on yourself.

pros} nice paint,} heavy steel well made} comes with hardwareCons}} The clips that retain the headlight in the bucket are an antique design lots of younger guys have not seen}the bucket is shallow so I could not make a old fashion sealed beam bulb fit} the bucket is shallow there is no room to mount switches in it} maybe an LED bulb would fit better

finish was ok