CRL P995WS Clear Bottom Wipe with Drip Rail for Cambridge and Crescent Sliding Shower Door System for 3/8" Glass 40" Length

Fit well and was easy to install.

Our glass slider bottom wipe / drip rail had cracked over time (6 years) and was leaking. This product was a good fit for the 3/8" glass. You will need a special pin spanner wrench, and thin wrench to remove the roller wheels that suspend the Glass. Your doors may be different, but ours each had 4 wheels up top, and you need to remove the 2 lower wheels, so you can lift the glass up about 2", then remove and replace this plastic drip rail (without damaging your glass, I might add). You need 2 persons to do this job. One to lift the glass up about 2 inches, another to install the bottom rail. 3/8" glass is heavy, and unwieldy, be very careful with glass to avoid any damage. I had a beveled edge which accidently got damaged during this process, not huge damage, but no longer perfect. Take my advice, and get a helper.

Perfect fit and works better than the one that came with the shower door.

The product did a good job. My husband installed it on the shower doors. Working fine so far

Fits very tightly, which is good.

The media could not be loaded.

The media could not be loaded.  It’s doing what I need with the assistance of some caulking. I wish it was tight fitting without the caulk. It does go on easy and it’s easy to trim down. Overall I’m satisfied.

I have the OVE Sydney shower door. I had been searching for so long for a bottom shower seal that would fit over the bottom center bracket. I’ve ordered multiple ones, but none of them were made for this kind of a set up. The company that sells the door quoted me $15 for the bottom seal + $23 for shipping, so I decided to forget about that. This seal is a perfect fit! I used a hacksaw to cut it to size and somehow we managed to get the seal on without removing the door. Very very satisfied - great product!!