Rox Speed FX1R-P13RIN 2in. Pivoting Bar Riser for 1-1/4in. Handlebars

Just what I needed. Angled it to add 1” rise and 1.5” pull back. Not difficult to install. You have to be clever installing it if your angle of installation blocks your way from tightening the bolts…. but doable.Quality built and looks good.

Bought these for my 2021 Harley-Davidson Pan America (RA1250S) and they work.

it is a good product, but it did not fit on my bike. I gave only 4 stars because when I return it, I only received haft of my money back.

I have the Kawasaki Vulcan Vaquero and have a limited choices for extending my handlebars which they mount way down inside the triple tree? No idea why. After installing a set of straight risers that lifted the bars about 2" my short arms wouldn't let me sit back properly in the seat, so I found this item on Amazon, and it mounts inside the original space where the handlebars go.Then you just rotate these extenders so you can get another couple of inches pullback and add the handlebars into place on these ones.Before I was leaning forward and holding the grips by my fingers. Afterwards, I can sit back, and the grips are now in the palms of my hands. FYI - I'm 5'5.Overall, it's a bit of a 'jerry rigging' affect, mounts inside mounts then connecting the bars, but it worked. I did have to remove the master cylinder brake line and reroute it then securing it again to the master cylinder as the pullback is too much for the stock line. No need to buy aftermarket lines to use these, at least on my bike.I haven't experienced any kind of loss of control considering this setup with the bars being far removed of the triple tree like this. The bars also rotate up or down inside these clamps.Note - there is a particular pattern to the installation, with mostly tightening the lower mounting bolts on the original mount where these rises connect to, which will end up underneath these when rotated forward towards the rider. Once these are rotated, tighten the upper mounting bolts that secure them. Then add the handlebars.

I’m 6’ 2” and these risers are perfect for improving my stand ride position on my Pan Am.

Perfect fit for my BMW 1250 GSA, easy to install and love the way my bars sit now.

Needed to raise and pull back my bars on my HD Pan America. Other companies offer fixed risers with fixed pull back options. These Rox Risers give me the ability to adjust a bit of the pull back to rise ratio. Gives more of a custom set up than the more expensive fixed risers I've seen offerd for my bike

Due to design, you either get 2” back and 1” up, or 2” up, and 1” forward. The access to the bolts limits the options due to placement and design.