NVX XFLOC4 4-Channel 160W Adjustable Line Output Converter with Remote Turn On

Great little device used to add a sub to a '25 Ram 1500. Once you locate and confirm the speaker wires for the rear door, it's super easy to tap them for this converter ..which then sends a signal/sound to the amp. No need to remove any dash skin or mess with the factory radio! This device also has a remote out (wire) to send signal "turn-on" the amp. (ie; no need to run blue wire all the way to your stereo or dash area anymore. Simply run the blue "remote wire" from this device to your amp. Always, Always check, confirm your ground wire (black) and 24v (red) are correctly terminated then protected (wire nut, tape, heat shrink) before connecting 24v power from car battery to the amp.

I added a subwoofer to a G37 Convertible using a wire tap from the rear 6x9's and it works very well. This allows the factory head unit to utilize the bass adjustment from the Bose system to work just like having a separate subwoofer volume control. It's a quality product. I'm going to be using more NVX products. Sound quality is fantastic and the input controls work extremely well. I'm 100% pleased with this product.

Just thrown in a bag and you figure it out, I expect that when buying something used. Not even a post-it note saying good luck. And yes, I'll figure it out.

If you buy an Android auto stereo, YOU WILL NEED a line-out converter to install an aftermarket amplifier. Cut the high-level outputs [the speaker wires from the head unit to the factory harness] and wire to this line-out converter to the side going to the head unit. Then wire the amp high-level output [plugs that came with your amp] to the side going to the factory harness. Ensure you wire the 12v positive [red] from the line-out converter to the head unit 12v positive, the negative wire from the line-out converter [black] to the head unit negative, and the remote amp signal [blue] to the external amplifier remote signal input. Test and enjoy.

This is the key for connecting your car speakers to your amplifier if doesn't have LOC built in your AMP. Easy to use, has a manual and how to connect wires to the radio outputs. Works fine and the big plus it has a blue wire (remote) that connected to your AMP remote wire will turn it ON without you having to run an extra wire to your fuse BOX for remote wire AMP to turn ON - This saved me some time in long run. Works great so far, no noise, from engine or whatsoever.

Hello,I recently purchased this NVX XFLOC2 2-Channel 80W Adjustable Line Output Converter with Remote Turn On and this converter cut on and off!when I finally figured it out it was definitely this one!if you dare buy this cheap one,remember this will happen! unless you have 3 hours to kill with no results!

Works well, not high power allowed but its ok

It came on time, and it worked. It did however come with either an incorrect instructions or assembled with one of the wires the wrong color.