Skelang 2 Pcs Jack Stand Pad, Axle Stands, Universal Slotted Frame Rail Protector, Pinch Welds Protector

Used for the first time last week, they dont sit on the axle stands I have so have to force them on. Sort of stretching over the axle stand, which means they are on tight and wont ever slip off.They gripped the sill jacking point and raised the axle stand when jacking the car up to remove said axle stand. Not sure if better with or without them.

The Pad fits the top of the Jack Stand but only when the weight of the object it is supporting rests on top of it. The width of the recess in the bottom of the pad is to wide. This may cause a tilt I have yet to test it.

These might not fit every AXLE STAND design, but mine fit well. A bit expensive at a fiver for each pad !

I have tried these on 4 different jack stands and it doesn't fit any of these. All big brand stands and nothing even close to fitting.

These fit perfectly on my axle/jack stands which have the concave rounded support. The groove is enough to accomodate the pinch seam and the two flat parts, either side position on the reinforced pieces on each sid eof the seam.Much safer and minimises any damage to the car's paintwork.No fancy packaging, just a small ziplock plastic bag which may also be used to keep them together until it falls to pieces!

Not suitable for lifts associated with on Amazon so looks like a lot of people probably make same mistake

Fits jacks perfectly

good