Stainless Steel 25 Pcs Fender Bumper Washer Bolt M5x20mm CNC Finishing Washer Engine Bay Dress Up Fastener Kit Flares Widebody kit Installation Hardware

High quality product! Very satisfied!!

Ya me entregaron el producto gracias

It's OK. Some of the bolt got cross threaded when removing the bolt

I ordered the more expensive 5m stainless steel set for use on my fender flares. Worked out great; EXCEPT that it didn't come with the 3mm hex/allen wrench pictured and in description. Luckily, I happened to have one - So I'm docking 1 star for that.Otherwise, it seems a nice quality set.The rivnuts are very hard to manipulate with a lower end (cheaper) rivnut gun. They aren't cheap steel, but hardened aluminum. My forearms and hands (heck most of my upper body) are still hurting a day later, but that just lends itself to the quality. Do yourself a favor and pick up the drill attachment rivnut tool or the large double-arm rivnut tool - You'll save yourself a lot of suffering.

I found it virtually impossible to use the ends of the bolts and lost more in the space between the exterior body and inner metal wheel well. Even using a long bolt the same size to hold in place while screwing from the outside they fell inside the space between the wheel wells. Finally googled it and got some compression type molly basis that compress to pancake behind the body but face would not go through the whole. This worked like magic and now I have 7 left over finger tightening finger bolts. If you’re going to use the finger bolts get a 8 inch long bolt that fits them drill the holes through the body and a larger one through the metal in the wheel well . Use the long bolt to match the finger bolts to the exterior holes and screw together from there. If you go very tight you should be then able to unscrew the second bolt used as a guide and it will be extremely tight.

Took about 3 hours to drill out rivets and install new rivnuts for a skid plate .I start installing the skid plate and get a couple of the screws started then use my impact to zip them in and bam its cross threaded.I start examining the screws and notice about 10 of the 25 pack are a different thread this is unacceptable. Both packs have the same amount of wrong thread screws .

My mistake for not reading the size. I'm used to fiberglass fender washers all being twice and large. These are not for offroad use holding fenders....I will use them for interior lite materials.

No se si no vi bien las especificaciones, pero no me funcionaron, pero muy buenos acabadosSi son pequeñas las piezas