Forza Bolt-on Axle Adapter for F-2 Trainer

I was glad that I read the reviews of the bicycle carrier & several of the purchasers of the one I chose said that I would need this product. I took their advice & I'm glad I did.

This is all you need to convert just about ANY trainer to handle a track bike. The only thing you need to ensure is that that this will bolt on(look at the insides of your current setup. If there is a bolt holding the axle cup in place, this will work). That's going to be about 90% of trainers.*Additional information: Some Tacx trainers do not have removable cups. In those rare cases, you'll need Tacx axle bolts. Btw, those axle bolts are also an easy way to convert just about any trainer to handle track bikes as well.

too bad bolts didnt com ewith it i went to hardware and didnt fit so need to do more research find right bolt to fit

It holds my bike wheel in place, but is pretty expensive for just a small adapter. This should really be included with the trainer.

I only needed one for the right side of my bike and it was easy to install but you will need a #5 Hex Tool. In my situation the shifter mechanism on the right rear had a screw head sticking out that prevented the socket from fully seating on the axle nut and so I went to the bike store and picked up an extra standard fine thread bike axle nut to screw onto the remaining thread and that took care of the issue along with the fact that I also needed the adapter for the right side. My guess is most will only need one adapter if their bike is a solid axle without the quick disconnect.

These really should be packaged with the trainer. I ended up purchasing 2 for the bike I'm using. Depending on bike you're planning to use you may not need these adapters wait and see.

WHen I bought my bike stabalizer, I was told I would need two of these. I did not. They came with the unit. Wait until you get your stabalizing station before you order these. There is nothing wrong with them, I just did not need them.

This bolt-on adapter for the Forza trainer is great. Well made. Does what is intended. I only wish the trainer itself came with these to begin with...Note: Buy 2 of these! I got one and found my bolts (Schwinn Seneca) fit in the existing adapter on ONE side, but it was a bit sloppy. To prevent "slop" or other potential damage, be sure to get two of them. They simply install with an allen wrench, replacing the existing one. The inside of these are tapered to allow the bolts to slide in, no matter the size.