iJDMTOY Smoked Lens Dynamic Sequential Blink/Flow Amber Full LED Front Side Marker Light Kit Compatible With 2018-2020 Buick Regal, Replace OEM Fender Sidemarker Lamps

Product appears to be high quality, OEM-level build. Would highly recommend for anyone looking to convert their clear side markers to a LED tinted version. Super easy install; about 5-minutes in total.Help for Install:Work was done on a 2018 Buick Regal TourX. Look at your new lights and evaluate which is left and which is right. They are labeled on the molded plastic housing (backside); right (R) is passenger and left (L) is driver. There is a flexible tab at the front of the light and a locking tab at the back. To install, push your existing light forward, toward the front bumper. This will compress the flexible tab and allow you to pry the back of the light out from the fender. Swap the electrical connector by twisting out the plug and pulling the amber bulb straight out. Plug in your new light and assemble in reverse order (front of the new light goes into the fender first, compress the flexible tab, push in the rear until the locking tab grabs the fender). Slide it back and forth to make sure it is seated properly in the fender opening.Hot tip: install both new lights but leave dangling out of the fender. Go in the car and press you hazard light switch. Verify that both lights are functional. If not, flip the position of the black/red wires. It's likely you've mistakenly installed with the wrong polarity.

The media could not be loaded.  I'm not sure about how the UV light will treat these... But right now, they look awesome!If I had to do it again, I'd get clean and smoke them my self. That way, I can ensure UV resistance, but unltimately, time will tell.They look trick!

Got the smoked version for my 2018 Buick Regal Sportback(2.0T). Looks amazing. Cycles perfectly with the headlight signals and Is a much cleaner look! Not to mention it took 5mins to install.You pop the light out(easy to do and is talked about in the instructions.Unplug the oldPlug in the newCheck that they work with the hazards before reinstalling themPop back in and you’re good to go.

Bought these for my 2018 Buick Regal TourX. Quality appears to be good. Fit was perfect aside from having to cut off the wiring connector. I love the look of the smoked lens on my white car.

These bad boys are super easy to install just push existing lights forward towards the front end and pry up lightly with a towel covering a flathead screwdriver

These lights fit and look great on my grey TourX. Installation was easy, but not explained. You can push the light slightly towards the front of the car and then pry beneath it with a pry tool. It should pop right out, then you can twist the bulb out of the original light to release it. Then pull the bulb out and connect the new indicator where the bulb was. I don't think it will hurt to plug it the wrong way, but if you pull the tape off the connector temporarily, you can match the black wires up on the wire and the new indicator.Very pleased with the result.

Nice upgrade over the OEM clear housings

They were a simple install, and on a black car they blend very nice. The sequential pattern is really slick too, and unlike others I've seen, the dot lettering is right side up!