AwclubWaterproof Dustproof IP65 ABS Plastic Junction Box Outdoor Universal Electric Project Enclosure Gray 2.48"x2.28"x1.37"(63mmx58mmx35mm)

This is my third attempt to get a box the fits this board the dimensions given should have fit oh well let’s buy another,,,

Great project box overall. I had to modify it a bit for my needs of running a few cords in and out of it (extension cord in, other devices plugged in inside the box, then those cords running out of the box).So I cut a notch in the side. This ultimately made it not waterproof anymore, which was fine for my purposes.The only downside I experienced is that the box comes with 4 holes outside of the waterproof box area for mounting (which would normally be a good thing). However, in order to use them, you need extremely thin screws (thin screw heads too) that can travel down a cylindrical area of a few inches. That didn't even come close to working for me. Easy fix: I drilled 4 holes in the bottom of the box and used them to mount it.

Built a plug and play adapter for snowplow headlights. Plug the truck wiring into this box and 2 pigtails come out, one attaches to the truck lights and the other to the plow lights. The circuit I built inside automatically switches between the truck and plow lights when the plow is attached. I was unsure how it would hold up with the heat in the engine compartment but It has made it through 2 winters so far and still holding up great.

I needed a small project box to mount my Rinnai water heater controller and this fit the bill, perfectly. The build quality seems to be on par with expectations. My only qualm is I wish it had the same length and width but had been about 1" deep. That aside, it was perfect for the project at hand.

The box is sturdy and has good seal that you do need to carefully cut to size.The screws rust and after half a year in my Los Angeles back yard (almost no rain) I can't open the box.I did find metric M4 screws (12 for $2) at Lowes that will not rust and fit right in.I will be getting another box because this one needs to be replaced. I wish the box came with better screw or at least not advertised as waterproof.

The plastic box, itself, is sturdy. It comes with a length of gasket that you must cut to size and fit into a channel around the edges (so be careful! If you cut it too short, there's not enough for a second attempt!)The screws go thru the box at the corners (obviously) outside the perimeter of the gasket. The screws are much longer than necessary, and very fine threads, so you have A LOT OF turns to tighten them into place. Also, the screws are not rust resistant and quickly begin to corrode. The attached picture shows them after a few weeks.

Shipping was great. Very awesome project box to have. You can cut and drill holes in the box and it is still sturdy. Be great for a junction box, geo cache box, or stuff like my project (pic provided). Highly recommended.

Worked nicely as a junction box for three overhead lights. Also had enough room to make a toggle switch to turn them off.