Noico Red 315 mil (8mm) 9.5 sqft (0.9 sqm) Car Sound Insulation, Heat and Cool Liner, Self-Adhesive Closed Cell Deadening Material (PE Foam Sound)

Lined my van roof with this to stop the build up of condensation. I only needed half of a 3.4sqm box so have plent left over to do under the ply lining. Adheson is good, well worth using a heat gut to make sure the surfce is dry and maybe warmed up a bit to help it stick. Worth getting a roller to help apply it and don't pull it to hard or it stretches a bit.Would definetly use this again on my next van.

Great bits of material, highly adhesive which makes it a little tricky to stick as you have only one chance to get it right. Sound deadening is fantastic.

Good quality

I used the noico 80 first, then put noico red 8mm on top in my car boot, although it doesn't completely sound proof the car boot it definitely quietens the road noise quite a lot

The product was amazing and significantly reduced the noise levels in the vehicle.

Great product used alongside double foil insulation on roof of my van, definitely makes a difference, plus it's so simple to fit.

I used this for my van as I got fed up with my kit getting wet from the condensation dripping from the roof I would recommend this product to anyone with an van so easy to fit just sticks to the roof and sides of Any van

I’ve used other products from this company and this is the first one to let me down insulation for your car maybe sound deadening not really

I used this product in an off label fashion to help semi-attractively insulate the inside of the rooftop door that was cooking our whole second floor. The door is thin and crappy but I can't get it replaced (landlord's 🙄) and I needed something that didn't look TOO tacky. This has done the trick! Our electric bill has already thanked me, And it doesn't look half bad. BE AWARE: ONCE ANY PART OF THE ADHESIVE BACKING MAKES CONTACT WITH THE SURFACE IT IS STICKING TO, YOU ARE NOT MOVING IT AGAIN. THAT PART IS STUCK AND EVERYTHING'S MOVING AROUND IT. It will not come back up without tearing and being scraped off and cleaned back to base. I suggest only removing a small corner or edge of the protective backing for each piece you're placing, lining it up very carefully before making any contact, and then smoothing it all down. I am talking you make the slightest brush against the surface would be adhesive backing and it's done for. If you do get a bubble you can poke a small hole through the foam, and just squeeze the air out from behind the panel that way. Since I was using this to insulate a wooden door I covered the door with that easier to remove adhesive vinyl that some people use for book covers and such first to protect the wood. Because this stuff is a pain to get back off.

Ottimo prodotto

Très bon produit

Really easy product to use. You can cut & shape it to fit really easily. Made a good difference to my van by reducing noise levels. A bit expensive for the amount of product you get. No complaints with it so far. You need to be careful applying it as once it’s stuck on it’s impossible to remove without tearing it.

Bought this insulation foam to pair with sound deadening to help improve the audio in my cars. This foam works great and the adhesive is very strong. Make sure you wipe the surface clean and do a mock up of where the foam sheet will go BEFORE peeling off the backing. Once you peel the backing and stick it somewhere, it'll be stuck there and very hard to remove. Besides using as sound insulation on the doors, I've also cut these into tiny strips and use to insulate between aftermarket car speakers and their respective adapter brackets. One box of 36 sq ft goes a long way.