IRONTEK 1.5'' 5x114.3mm Wheel Spacers for Ford Lincoln Mazda 5x4.5" Hubcentric Wheel Spacers (1/2"x20 Studs, 70.5mm Hub Bore) for Ford Mach I/Mustang/Edge/Crown Victoria Mazda Navajo/B2500/B3000/B4000

Not much more to add. If you're looking for good fitment in the rear on a 94-98 mustang with OEM backspacing, try 1.5"

Fit my truck great so I could install my new wheels!

Worked well.

Have over 6k miles on them so far without issue. Black finish has held up better than expected.

The spacers fit perfectly. However the studs that are in them are complete junk and super soft. The lug nuts looked a little questionable but not a big deal since I bought aftermarket ones anyway. I did buy new studs from the parts store but other than that they are good

Exactly as described. Good finish that has held up well so far.

FIT PERFECT NO VIBRATIONS

Bought these due to some tire rub on my car. Initial installation wasn't too difficult, on my rear hubs the center hole was about a half milimeter too small so i had to wire brush the insides of the spacers to get them to fit, no big deal. Torqued everything down to spec, after about 2 weeks of driving (50 miles or so, I don't drive too much.) took off my wheels and re-torqued the spacers to the hubs and the wheels once more. Today on my drive home i notice alot of vibration and noise while making a turn, stick my head out the window and see my driver-side front wheel about to fall off the car! Pulled over to see two studs had broken and the other lug nuts hand tight. The wheels havent been touched since i re-torqued everything, and I made sure to double check the torque on all the wheels before driving due to my suspicions on these spacers. Would not reccomend anyone install these, as they are a massive safety risk.