Powerbuilt42mm Socket, 3/4-inch Drive, 12 Point, Thin Wall Hex Strong Grip Design, Size Markings - 943245

fits like a glove fast shipping

ok

Used this on a spigot with very heavy deposits. I had to chip off some of the deposits just to get this started. Worked it back and forth slowly until it was fully threaded.

Great

I needed this socket in order to remove the oil filter housing for my 2007 MB ML500 - the gasket to the cooler and mounting needed to be replaced after 150k miles and 12 years of faithful service. The nut is in the oil filter housing and was relatively easy to remove with this. Only thing is I don't have a 3/4" ratchet and needed an adapter to get it to work (guess what Amazon has this as well). It maybe a one use tool, but it was cheaper than getting a mechanic to do it.

The quality of the socket felt great. I probably wouldn’t use it on a impact driver but on my breaker bar and torque wrench it was great. I used it for a oil filter housing job on a mercedes m113k engine. It was used to tighten the main oil filter housing bolt to 51.5ft lbs. The price was great and shipping was fast.

Works fine

It worked fine

Purchased this socket to remove the rear pinion nut on a 2017 f550. Worked great. Cheap socket and will last forever since I don’t use it very often. Even if I did use it everyday, I bet it would last years.

I have used the 42mm socket with a breaker bar to loosen the pitman arm on the jeep Lots of torque and it is in the great shape

Nice chrome finish.

Bought this to use to press in a bearing into a 98 Jeep Cherokee AC Compressors Clutch. worked like a charm.

This socket was 1 mm smaller than it says it is. Was too tight to do the job, i had to go buy another socket from auto supplier