1:10 Rock Crawler Axle, Aluminum Alloy Front and Rear Axle for Axial SCX10 RC Crawler Car (Titanium)

Great very nice machining and very clean. Was sceptical abought these from the price. But when I got them I was very suprised how great they turned out! I have been scratch building crawlers before you could buy them. And for the money these exceed any axles out there. I've put a lot of Vanquish axles under my customer's builds but these are a life saver on there pocket books! You can put any axial upgrades you want in them if you decided you want some different options. I would recommend these to anyone!!! Just ordered 6 more sets!!!😊

The axle housing is great. Heavy and feels well built. The dog bones are terrible breaking instantly not sure why they sell it with them. The gears stripped.

Had a miner issue with the rear axle, but the customer service was amazingly helpful I would highly recommend these axles!

Housing and exterior construction is well made.However gearing is reversed from stock axles (Reverse is now forward). The differential is a bit large but it helps lower the center or gravity. The front axle shaft broke after some medium use. But it’s the same as a stock on so parts are readily available not a big deal. Definitely need grease before use and a once over with some lock-tight and new fasteners for anything that’s striped or loose. Probably won’t buy again but happy with the purchase.

I was skeptical they would last, but here's what they look like after ~8 months of use in my backyard course, which is all jagged concrete that you see in the background.They're also pretty heavy. See like decent value for the money.

I broke the shaft as well pretty quickly. I pulled the stock dog-bone and cup out of my stock axles and put them into these axles. They fit fine and should be much stronger.

Haven't even taken it outside. I installed the axles and did an incline test to see if there was improvement, the gears sheared immediately (my truck weights about 8lbs). The design of the lower link/shock mounts are very aggrivating to assemble. You will need a washer between your link and shock and they're not exactly easy to finagle. You have to work a horizontal bolt through the mount, the link, waster, shock, other side of mount, then attach a nut. Changing out my springs takes twice as long as before. Also the pumpkin is large for scale. The gears aren't good and dogbones are a bad idea. the stock scx10ii ar44 axles use u-joints and are way stronger. This is a downgrade, not an upgrade until you install scx10 gears and lockers.I searched for days and never found replacement gears; Axial branded ax10 scx10 wraith and eco gears work (AX30395) with diff case-small (AX80002) and heavy duty locker (AX30500) to replace diff gears. Will update when applicable axle shafts are found.

I recommend not buying this product. Unless you constantly like replacing axles. They Constantly break after turning the hub rubs against the axial wearing it down until it eventually snaps. Then just recently my sway bar snaps. This is my 2nd set I thought the 1st one might have been defective. I was wrong same thing happened to the axle. Now the sway bar snaps up in half. Thank good I’m an r/c Enthusiast with a lot of parts. To fix thing because I hate returning something the 2nd time this time I couldn’t get a replacement. They were gonna Refund and 10 dollars less then what I paid because it was used. Don’t make junk and it won’t need to be returned. Poorly made and very disappointed in this product. And I purchase lots of RC parts for my many Crawlers. One tip spraying pb blast on the axle Preserves it a little more from wearing out and snapping The axles