Angle Simple Bathroom Sink Drain Stopper, Pop Up Design, Deep Titanium Gold | Brass Stopper with Stainless Steel Tailpiece, Only for Sink with Overflow Hole, Fit 1.61 to 2 Inches Diameter of Drain Hole

Push in and out stopper plug is a nice upgrade over the old school pull tab/lever type. After looking over the reviews I was at first I a bit concerned that the drain was too big to fit in the sinks drain hole. After I got the old drain out ,it was an easy fit with zero issues. FYI ,drain plug is shipped with a thin,removable plastic cap and tissue to protect the finish , remove after installation. Check the pics out for the measurements and see if your sink can accept this drain. I like the looks of this drain . It fits correctly , matches my old drain very nicely. It is indeed of all metal construction , very sturdy and well made. Be sure to use plumber's putty between trim cap and bowl. Took about 30mns to remove old drain and install the new one. Days later still no leaks and zero issues !

They match my faucets perfect. Good quality. Very shiney. Love them

Extremely well made

Only for Larger holed sink (Kohler) ! Confusing instructions ! Odd looking bottom “cup” shaped gasket (unconventional) ! Had to read for advice and hints, to keep “cup” UPWARD ! Same as when taking out of box. Key is “Plumbers putty” is better than silicone glue… But, I prefer Warmed WAX (from toilet seating wax ring - just the cheapest one). Sat in the sun, while prepping the unit… waxed the entry hole, bottom heavier, waxed the threads where it tightens to bottom washer. Wax the black O-ring (both sides). Install this black adapter O-ring pointing nose Down into drain tube… yes it’s sticky… but vinyl gloves are great. :D

Works great and looks good too

This is a beautiful gold and quality sink drain stopper. I returned it because the contractor said it is not the right size,

I am not going to say that folks who had bad experiences with this product are lying, nor am I going to question their competency with installing drains. I consider myself a competent DIYer, and can say that I ordered/installed two of these without issue. I was actually impressed with the quality of the materials. I had expected plastic tubing, but the whole product actually felt as if it were made out of some kind of metal. It was even oiled bronze color all the way down to where it meets the U-trap (or is it J trap?). Usually, the part that goes under the sink is a cheap blue plastic. After installation, the first test resulted in a very tiny leak. By tiny, I mean that you can leave the faucet running for about 2 minutes before a single drop made its way through. Turning the sealing nut about a quarter-turn fixed that problem. I did not use ANY additional sealants: no silicone, no plumbers putty. There aren't any instructions, so you should know what you are doing if you buy this product. Also note that there is one BLACK rubber washer that comes included with this that I don't see in the pictures. There are three clear/white washers that form the seal on both sides of the sink. The black one helps form the seal at the bottom of the drain, where you attach the assembly part that goes into the J-trap. I almost didn't notice that it had fallen off when I first installed the drain, but fortunately I did. I suspect that a lot of folks that had leaking problems may have lost this washer, because it doesn't stay in place very well and if you have a dark vanity (like I do), it can easily get lost and blend in. UPDATE: 2 weeks after installing this, I observed a small puddle in my vanity. This is because the rubber washers appear somewhat flimsy and seemed to slowly shim out of place. But this occured only one of the drains. I sent for a replacement and I had the same issue. I think that if you tighten these TOO MUCH, they will actually work less. So on my third try, I applied flex seal to the threads and hand tightened. This did the trick. As a result, I am downgrading from 5 to 3 stars.

Working well

Schlechte Qualität! Zwei Installateure sind an dem Ablauf verzweifelt, da sie ihn bis dato nicht dicht bekommen haben. Der kar war ein absoluter Reinfall. Habe mir nun zwei neue Abläufe eines anderen Herstellers bestellt.

Was too big for my sink. Made for a bigger sink . Bigger opening

Solid, well done. Easy to install. Plumber said that is a good quality. Recomend.