Superbat UHF Male PL-259 to UHF Male PL-259 Low Loss Digital Coax UHF Jumper Cable (6.56ft RG58) for HAM & CB Radio,Antenna Analyzer,Dummy Load,SWR Meter

I bought this to replace an older, slightly longer, coax jumper between my HF transceiver and antenna tuner.Immediately used it on HF bands using 80w-100w. The cable leaked so much RF it caused local devices (computers, etc) to behave erratically or simply shut down.Re-installed the original coax jumper and everything worked normal.My recommendation: do not use/buy these to connect HF RF equipment. They might work fine for low power devices (under 5w), but 50+ watts there is significant leakage.

Worked well. Looks! feels like good quality compared to another cable I purchased, which was at similar price and functionality. Cable length I had was enough to connect analyzer to radio. Screws on easily and snug. I don't know the product longevity though.

Nothing to dislike here it’s a simple dual male connector. Used it to connect the SWR meter to my CB and worked perfectly. It’s made solidly and looks clean

These are ok for the price. I should've spent more.

It will be functional but I would have preferred better quality pl-259 fittings. I bought it to go with my Bird wattmeter to patch into the feed line of my rigs.

That's not what I was looking for. I need a coax cable. I don't have a clue what this goes to

This product is 100% defective with a shorted center pin to shield. Luckily my HF radio has a basic swr meter or I would have destroyed it. I double checked with the continuity setting of two multimeters and confirmed it’s bunk.Avoid at all costs.

Great PL-259 mLe/male CB table to tie it my SWR CB tuning meter.

RG58 A/U cable with is 50 ohm and relatively low loss at HF and VHF. The PL259 connectors are well machined. This cable has a 1400 volt rating, or suitable for up to about 70 watts.

Both the cable and plugs seems to be well made and of good quality. The 12" coax patch cord is handy for SWR meters, tuners, etc. I ordered two more I was so pleased.

Not bad for a cheaper than good quality cables. Does add q bit of noise, but overall - okay. Main pro is speed of delivery and assembly quality - fast and good.

The product is well made and exactly what I was looking for. Yes, I could have soldered two ends on a similar jumper cable, but that likely would have cost more.

Will do the job just fine.