Sunco 4 Pack LED Can Lights Eyeball Retrofit Gimbal 5/6 Inch Recessed Lights Dimmable, 12W=60W, 5000K Daylight, 800 LM, Directional Angled Trim Adjustable Ceiling Downlight, UL

First, these are white, not the off white almond color in the photos. That’s good.After 5 years one of our Hyperikon recessed gimbal 2700k lights failed. I bought a 4 pack of these as a similar seeming replacement - turned out they were VERY similar but not exactly the same. These are the same warm 2700k at 30-100% brightness on the dimmer range, but these stay brighter than the old ones as they go below that into the lowest ranges of the dimmer switch. One of these also has a wavering light intensity in any brightness below 70%. Seems related to other items of the house powering or or off maybe.Otherwise good price and easy to install in the same connection and with the same color profile.

I bought 4 units, but one was defective. The seller reponded to my exchange request and promptly sent out a replacement.

Easy to install. Love that you can adjust the brightness

These lights are perfect at producing light. However, the unit, sold as a swivel light, did not allow enough swivel alignment. I replaced four incandescent swivels that I could aim. These will not sim where I want them.I have very high, slanted ceilings, so difficult to install and adjust swivel. These units seem to not be designed for slanted ceilings.

I like these features: Adjustable light color brightness 2700K to 5000K & Adjustable tilt!Recessed lights arrived poorly packed, resulting in badly scratched up lenses! Returned 1 box for replacement! Replacement arrived also poorly packed with scratched up lenses. A BAD experience! Great Amazon customer service response!

Torsion springs on these lights are straight horizontal not in a V shape like other similar products . This causes an awkful lot of effort needed to place them in the can. My first attempt to bend and place caused the spring to fly off its bracket and it hit me. I contacted the supplier and they were responsive, but unfortunately provided no immediate solution to problem. Lights were will constructed and offered a lot of features for the money. Will return.

The manufacturer of this light Sunco has a list of tested and approved dimmer switches. Don't believe the list they provide they do not work 100%.I purchased a Lutron digital dimmer of a specific model tested by Sunco and it does not work.The failure I had is the digital dimmer does not turn the lights off 100%, the turn down very low but never off.So I contacted Sunco and got this as a responseWe apologize for any inconvenience experienced by our product.It seems that you are experiencing an “afterglow” issue when the LED continues to glow permanently when the light switch is turned off.This may be due to the switch/dimmer being incorrectly connected, unfavorable cable routing or circuitry is too old to properly regulate the current so the bulbs are operating on lower power than what is flowing in the circuit.This particular afterglow issue is usually only visible after converting from old light bulbs to LEDs. Any leakage currents and induced voltages were simply short-circuited by the filaments of the old lamps but these currents are sufficient to make an LED light glow weakly.NOTE: Please consult with a certified electrician in your area.I then responded to them and informed them the units were installed with new ceiling cans and new wiring to the electrical panel. I also informed them that the issue is the dimmer which leaves a small voltage on the line to feed the LEDs in the dimmer. This feed is enough to power 4 lights perhaps more but I have 4 per dimmer. Installation was done with a certified electrician. I also stated that at the bottom of the dimmer they have an emergence pullout switch to cut the feed out. When this is pulled out the dimmer switch LED turns off and so do the Sunco lights.So i purchased2 packs of 4 LED lights 49.99 each for 99.98 total2 Lutron dimmers at 65$ which can not be returned and do not workSo the cost of 8 lights is 165 not 99 buyers bewareIf you have a problem with the dimmer light combination the light manufacture technical support is not adequate to comprehend or own up to the issue.So use a mechanical dimmer, or buy a different light.You can not return installed dimmers due to the other manufacturer's improper testing and recommendation. The dimmers also required breaking a tab to install them in a multi-unit switch housing. So regardless of how you look at this, I spent 65$ more for these lights due to their poor testing of dimmers.

Great purchase for a fair price.

The product can be install in existing incandescent pot light can. I installed all four in 20 mins. They look fantastic and I love it.

One of the four lights was DOA. (Dead On Arrival) But you don't know this until you install the lights, given the fact that I'm not part of the manufacturer's quality control group. Installed the lights way up - WAY UP - under the eaves of a second story, at great time and expense ONLY TO FIND ONE OF THE LIGHTS ARRIVED DEAD. What China fails to understand is that the actual value of the lights pales in comparison to the COST of re & re. In this case, 4.5 hours to go up and remove all of the lights, box them, do the paperwork, and ship back.