RIVERWELD Argon Gas Flow Meter Scale Tester Measure Flowmeter

Learning to TIG weld, and things were not going well. After purchasing this, I discovered that what my on-tank flow meter said, and what was coming out of my torch were vastly different.I set my flow rate using this device, and TIG welding all of a sudden became SO easy. By far the best money I have spent on welding supplies. Trust, BUT verify........ (I put a piece of masking tape on the scale of my flow meter, and marked it correctly based on what was coming out of my torch.)

Junk. Bought 2 one doesn't work because ball is stuck all the time. Other one is abt 10 CFM off. On my part o didn't realize they weren't measured in CFM but they refused my refund within minutes ilof ordering. They said product had been shipped. Yeah right

Good does not brake when drops.

The chamber tapers in a way that allows the ball to jam up very easily, requiring disassembly and careful handling in order to use. I found it almost completely unusable until I made a wire insert which allowed the ball to remain loose. Once this was done (see images) the gauge measured flow consistently with a machine mounted flow meter

Great product and price

The ball likes to get stuck in the bottom and will not indicate flow. It reads several CFH lower than the flow meter on my Miller so the question comes up - - which one is right? Since the ball loves to stay stuck in the bottom I am going to keep trusting what the Miller gauge tells me and scrap this thing.

Its a nice tool to have around when you are checking your argon ga vrs what you are getting at the torch end.

Looks good But hard to see pressure and is not very accurate, disappointed at best

Good product and Fast delivry

Super ce controleur de debit pour gaz argon sur poste a souder mig,il se met au bout de la torche et permet de connaitre le debit de gaz pour vèrifier l'èxactitude du manomètre et s'utilise aussi avec le detendeur sans manomètre des bouteilles jetables.

Sehr Praktisch, um den Argon oder Mischgas-Durchsatz zu messen. Auch als Überprüfung, des aufgebauten Drückmanometer, zu verwenden!! Zum weiter Empfehlen. Sollte bei keinem Schweiß-Vorgang fehlen!!

No me gustó no es funcional para mi

I'm using this to check my gas flow when setting up my tig welder. Even if you have an accurate gauge on your regulator its worth having one of these to make sure everything is working correctly. It turned out the first regulator I bought was faulty which I would never have discovered without this gauge so in the end this cheap little tool saved me a lot of gas. Definitely recommend for peace of mind.