MPC-E

I installed this onto my Kawasaki Versys 650 ABS Gen3 into one of the two optional 12V cut outs on the dash of the motorcycle. I installed the required OEM Kawasaki 12V relay under the windscreen cowling to activate the pre-wired 12V accessory wires behind the dash cowling. You have to get the relay to activate the 12V pre-wired harness on the bike. There are 4 12V pre-wired connectors on the bike. Two under the windshield cowling (USB port & gear indicator) and two under the left radiator shroud for the fog lights and heated grips. Popped off the round plastic plug and inserted this dual USB outlet into the dash opening. I did have to lightly sand the opening, as it was too tight to push this USB outlet through. Installed the locknut from behind. I clipped the ends of the supplied wiring and crimped 3.9mm male and female bullet connectors to the supplied wiring. Then plugged the bullet connectors directly into the factory bullet connectors on the left side of the cowling. Pretty much plug and play. You just have to crimp on those 3.9mm bullet connectors to plug into the factory wire harness. It's been working great! I use it to charge my iPhone Xs Max as I use Waze to navigate on my commute/travels. The rubber cover was annoying with the one USB cable always plugged in, so I removed it. I just used a rubber USB port plug to cover the unused USB port for dust/water protection. The factory OEM Kawasaki USB port is $80 + the OEM Kawasaki relay is $20. You can wire it direct to the battery, but if you install the OEM relay, you can use the factory wires to plug this USB port directly. The USB port only turns on with the ignition turned on. It won't drain the battery with the key out of the ignition if you use the facttory relay and factory wiring.

I like that it has the voltage display and it is easy to mount and comes with a good length of wire it has all the mounting brackets and what is needed to mount it. It is a low profile and it mounts nice. I would recommend this to anyone wanting to add usb outlets to their car or their boat it is great for those uses. I would recommend this item to anyone

Update: the contacts were loose. Probably my fault during installation. Soon after installing, one of the two plugs would charge intermittently. Every few seconds it would charge, stop charging, charge. After a couple years the second charger completely stopped working. The voltage reading is all over the place with one of the lights burnt out. I would have replaced it earlier if it wasn't so difficult to do

For the price it is a good product. Doesn't feel like very durable, but this is nothing you handle all the time. Looks good when install and installation is a breeze. So far it works well. We'll see if it lasts.

It's not like the build quality is amazing but it was quick and easy to install and does exactly what it says it's going to do also if use the Samsung cord a will fast charge Samsung phones

In adding phone holders to the vehicles for hand free driving, we thought it would be nice if we got the wirelessly charging ones, which needed better power than the existing cigarette lighters. These fit the bill- the 3.0 powers the wireless chargers, and it nearly fit in the stock cigarette lighter hole (just a little dremel work, very minor). The voltmeter is a nice bonus.

It worked great for the first 3 months. Now it will not charge unless you lift up on the cable. Have replaced the USB cables and nothing changed.

Just got my usb port and very nice construction. Fit in my factory hole where the cig lighter was at without modifications. Straight forward and Very easy to install. Works great! The voltage readings are accurate, top usb port is the quick charge port, and the bottom is just standard charging. I searched and read for almost a week before i decided to buy this one because it had the most info about it and a warranty. If you wanting a usb port this is the one! ❗️❗️❗️❗️❗️❗️❗️❗️❗️ UPDATE!!!! So I bought the cig lighter usb “fast charger” conversion plug on October 2019. Today is April 18th 2020 and I’ve had enough so thought I’d share the issues I’ve been facing. I’d say around January I was getting intermittent charging or my phone would just in I to charge then out then in, over and over. I thought it cannot be the plug it has to be the cable. So I bought another cheap 6$ cable, worked for about a week then same thing going in and out charge. So I buy another cable blunt this time decide to buy a nice cable that’s mifi certified belkin cable..once again everything was great for 5-6 days then back to in and out charging. I took the cables inside and tested them all in a wall plug and they all work great. So after testing many cables in this converter! I Order a usb tester and test both ports and the one that should be fast charge shows 5w the exact same as the bottom plug! And this plug is by far mifi certified!!! I’m pretty pissed now because I have done cut my cig plug out to wire this junk thing in now I’m gonna have to figure out something else to mod up or find one these that are mifi certified