Right Angle Nema 5-15P 15A 125V AC Plug, ETL Easy Assembly 90 Degree USA Canada Male DIY Rewirable 8 Directions Adjustable AC Connector

i don't give 5 stars but in this case these plugs are well thought out. good design, easy to use and can be indexed to exit on the side, top or bottom. great, nice job...

Just like the Title Description says these are quality great replacements for almost any small 110volt window air conditioning units. Bought these because the reset type breaker plugs on my air conditioners on 2 of them one day tripped/shut off and when you would try to push the reset button to get the unit itself working again, it would not stay switched like the button was broke. Now this was on a three month old air conditioner so I knew the air conditioner couldn’t have been broken already and like I said I had another air conditioner window unit that did the same thing so I found these on here and rolled the dice and replaced them on both units, And now both units are working again. It’s safe to do this because if something happens or is wrong with the air conditioner after you replace the plug, you still have the circuit breaker at the panel that will trip/shut off if there is a fault/problem that is still within the air conditioner unit itself.

This plug's ability to be oriented in increments of maybe 20 degrees relative to the cord is something I've never seen before and very useful. Be aware the orientation (that you determine) is fixed once connected - it is not like another style of plug/extension cord where there is continuous rotation through 360 degrees.Attaching the cord is not easy - you need to be pretty handy, and the included "instructions" are less than useless. The length of all three wires needs to be tailored to the rotation you have selected, which is doable if you are handy and have appropriate tools, but probably close to impossible if you are not.The wire clamps (screws you tighten to fasten each wire) work great once you get each length, and the amount of insulation stripped, right.Some complaints in comments assert that being made of plastic, and having screws that thread into said plastic, is bad, and the screws easily strip. I can only say I had absolutely no problems in this regard. Again, may depend on experience and handiness.If you don't need the adjustable-angle feature, go with a simpler plug that is not adjustable and has a fixed length each wire needs to be (which still may not all be the same).

The plugs are very easy to use and the ability to rotate the plug body to the direction you want the wire to exit the plug is very helpful. The plug is very sturdy and well made. A little bit expensive but I feel it was worth it giving you the ability to direct the exiting wires in the direction you wish them to go. It creates a neat appearance to the job.

There are lots of bad reviews saying the holes don't line up or falls apart. The holes are lined up to one side of the screws or the other. If you wrap the wire clockwise around the screw and it won't line up, it was probably designed to wrap counterclockwise on that screw. If I remember correctly ground and neutral were both clockwise and hot was counter, but don't quote me. It is difficult to assemble of using solid wire, stranded is much easier, but that's a problem with the wire not the plug, hence no loss of stars. Otherwise, it works perfectly, just don't overtightened the screws, if it feels like it's going to strip, something isn't lined up right or the clamp isn't intended to close completely, just enough to hold the wire from moving.

The original plug on my toaster oven went bad. I bought a replacement plug, but it did not fit well with the flat power cable that was on the toaster oven. I had to use electrical tape to seal the plug opening where the cable goes in. I did not like this. So I bought this plug and thought I would give it a shot. It fit perfectly, and the cable clamps tighten to an almost perfect fit with the flat cable. I wish I had bought this plug to start with.

Just what I needed to fix my mini fridge. Thought the fridge was going bad but it was just the plug. I replaced it with this one and bam it’s fixed and ready. I like the ability to adjust the angle. I would buy again.

This product is exactly how it appears in the pictures. Once it's assembled, I think it works fine. Assembly itself is a chore.- Main screw (holding the black body to the white plug) strips out very easily. Be gentle with it.- Strain relief clamp screws are VERY stiff. They take patienceI'm an electrical engineer and work hands-on with this type of connector pretty often for work. A good quality connector will be easy to assemble and hard to break. I decided to try something different for a little DIY project at home, and overall, I'm dissappointed with this product. It did the job, but I won't buy it again.