GoodridgeSpeed Bleeder - 7mm x 1.0, Size: 7mm SB7100

No problem with the product, but don't expect prompt service. Seller took payment but didn't ship product for 4 days. Not acceptable in the e-commerce landscape. 4 days is slow for a part-time seller working from home, but totally unacceptable from a retailer selling online.

These work great. Checked to make sure that they were operating before installing by blowinng air through the hole. Installed them without too much leakage as the system was still closed and capillary action held most fluid in the line and the caliper. They screwed in fine. Then about a 1/2 turn to make sure they were open and I could stand and watch the reservoir to avoid draining it completely and add more fluid. Just pumped away on the lever and it sucked everything ,bubbles and fluid very quickly. They make it too easy; no way to screw up an d you get a jam up tight, bubble-less brake bleed and no air in the line. these were 13 year old rubber lines. Next step - take it to braided stainless lines.

This is a duplicate of a review I wrote for another size speed bleeders:I cannot write enough good things about speed bleeders. These things are an awesome addition to any vehicle that you might be working on. Having these on your car is such a God send, it's just amazing. Bleeding brakes, or hydraulic clutches, is so easy with these. These allow you to flush old fluid easily, brake fluid naturally sucks up moisture, so clean fluid prevents corrosion inside calipers and master cylinders, firmer brake feel, etc. Oddly, when I finally bled that horrible coffee colored brake fluid out of the front of my suzuki the front rotor stopped squeaking!

I knew I was going to be bleeding the clutch by myself, so I ordered these. Worked flawlessly, and I have a clutch. Not the first time I've used these, and won't be the last.

These worked properly and make bleeding brake lines much easier. My only issue is with Powersports superstore due to the fact that I also ordered a 10mm version for the rear of my vehicle. The 10MM versions did not work properly and due to my installation of the product the company would not offer a refund. Unfortunatley, it is impossible to see if the product works unless it is actually installed.

These made my life so much better. I still bleed the normal way to get pressure built up, but it's nice to not worry about letting air back in the line. These also make flushing much quicker.

I had a set of speed bleeders on my brakes and they worked well enough that I decided to by one to bleed my clutch. This size works perfectly for a 2004-2008 Mazda RX-8 (possible 2009-2011 as well but verify this on RX8Club).

Installation was easy. I installed 3 of these in a 2002 SV650 and 2 of them in a 2006 SV650s (the rear is an 8mm). All of them were easy to install and worked perfectly.