FG-68025-HG Wheel Arch Molding - Gloss Black (02)

Flexible enough to go around the boat. Soft enough to cut for 90° turns.Used the 3M tape to secure it, then drilled pilot holes and then ran stainless steel screws into it.Great product, nearest product in the marine grade catalog was triple the price.

I installed on all four locations on a 2020 Honda Fit in about an hour total time, which included surface prep. The first wheel well was not quite perfect, but not sure if it is noticeable at all to a casual observer. The key is to keep firm pressure on the aligning strip as you work your way around the wheel arch. The aligning strip, which is at 90 deg. to the adhesive part, should be held tight against the underside of the wheel arch as you proceed. This produces a smooth curve once installed. No instructions came with the product, although it is not rocket science, as they say. I also could not find a video on the manufacturer's web site. I did find a YouTube video on a similar product that was helpful. The product comes in a flat coil about 16 in. in diameter. I found it helpful to elevate this coil to a level about even with the top of the wheel initially. I used a lawn chair. This way, you are not "fighting" the weight of the coil as you go. You can also move the chair/coil around as you go to minimize directional "pull" from the unused product. I dropped the coil down to ground level once over the top of the arch and on the way down. I really like the looks of the finished job. Besides the protective function, it dresses the car up a bit without appearing "tricked out". Durability still to be determined.

This stuff is awesome! I was looking for something to finish my fenders after I cut them, and this trim is absolutely perfect. Make sure to prep your fenders first, clean them super good and maybe even use a little carb cleaner to ensure good application. Totally recommend for pretty much every application, and make sure you don’t make any mistakes, as it is NOT forgiving. Great stuff though, would absolutely buy again. Bonus that it’s made in the US too. Hope this helps!

High quality trim. Adhesive works great. Used a heat gun to soften the material when going around corners and looks great.

Needed to replace the wheel well strips on my 85 300ZX. This product is awesome. Went on like a charm, simple and easy. As far as looks? Made a huge difference. Very recommended.

Easy application and good adhesion so far. Prompt shipping.

The right size trim I was looking for

Just about all laid down and ahered easily. Only had trouble with a small section I had installed, likely my own error given the rest has stayed on even at high speeds.Wish this was available in a slimmer format for the door edges.