EsportsMJJ 1/8 Inch BSP Quick Release Coupler Fittings Charging Adapter Kit for Air Rifles PCP

Used with PCP rifle and compressor. Works great !

Works well hood bit of kit

good

Used for Walther RM8 probe, fits well no leaks.

I recently bought a PCP rifle - Walther Rotex RM8 - and also a cheap hand pump. As I discovered most PCP guns require a 1/8" fitting for the coupling adaptor and annoyingly the stirrup pump was fitted with a smaller thread. Good pump for the money but an odd choice of fitting.Anyway, clearly this must be 'A Thing' because there are many 1/8" adaptors available and I bought this one. Which, works perfectly.The thing I do like is the quality as well. Lets be honest here, a PCP rifle is pumped up to around 200 bar which isn't small potatoes. You really don't want the fitting to pop off because the whip effect would nip a bit.So, I was very pleasantly surprised at the quality of this cheap adaptor. And being a Chief Engineer of many years having spend quite a few on saturation dive vessels I know a thing or two about pressurised gases the equipment used.In conclusion, I can't find fault with this adaptor. It's well made, works well and is relatively cheap.

I actually use this as a mount for the insta 360 x4 camera! I use a small adapter for the mirror bolt on the motorbike, attach this, then have a small adapter from male m10 to 1/4-20 (bolt for camera), after I had two mounts snapped and break. This has been used for months now and still works perfectly!

Used some bits on buddy bottle seems ok

Needed to add quick release coupler so that I could swap between BSA and Daystate fittings, worked perfectly.