3Pcs Camshaft Crankshaft Position CPS Sensor Kit 23731-AL60A 23731-AL61A 23731-6J90B Compatible with Nissan 350Z Altima Frontier Maxima Murano NV1500 NV2500 Pathfinder Quest Xterra Infiniti 3.5L 4.0L

Product arrived on time, quickly and once installed worked fine. Replacing this on the Nissan Exterra is not an easy job as they are located in a hard to reach part of the car. One tip that really helped, use a strap to hold the hood open as far as it will go so you can fit your body into the area you have to be in to reach the sensor.

They are perfect.

I usually dont write reviews but because this product is such garbage, I wanted to prevent someone else from aggravation and wasting their money.bought this for my 2006 Nissan Xterra. The vehicle started spitting out coded the passenger side one was bad. I replaced them both and got less than 10 miles before they went out. I went to Auto Parts store and bought name brand and it is working great. In my humble opinion this is Trash. Don't waste your money.

this kit was great as it was less than other parts that were single purchase.....very reasonable and my vehicle is back on the road!!!....one week later, already down again.......sorry, but your part failed........

It works fine

Out the box the crank sensor didn't work, but... The two cam sensors did, so after a trip to auto zone all's good.

This product arrived super fast but the only problem that I have so far was the crank sensor came bad for manufacturer but the cam shafts and fit perfect and are working perfect. Also the crank sensor fit perfect but I was those lucky people that the parts came bad for manufacturer. But I still recommend this company. Its good quality of products.

I got this for my 2007 Nissan Frontier V6 4.0L engine with over 210,000 miles on it. The cam shaft sensors worked fine and have had no issues so far in the last week.Now as far as the Camshaft sensor, it caused the truck to not start at all. Didn't realize it was the issue after replacing them all. Bought an OBD 2 scanner and to trouble shoot and got no codes thrown from the trucks CPU. Doing my troubleshooting and internet research and youtube videos thought it was a fuel pump issue. Ended up replacing the full pump and still the truck would turn over, just never start. Swapped out the cam sensor and put the old ones back in and same issue. Put the old cranksaft sensor in and then the truck started fine. Then put the new cam sensors back in, no issue then.So if you change a sensors and have issues, put the old ones back in, maybe one at at a time to see which one is the issue.Wasted 2 weekends, lot of time and frustrations and a week of a non drivable truck because of the bad new crank shaft sensor I got in this package.