Parallel this with a 4 ohm speaker get 2 ohm. If in series got 8 ohm, bad??

It depends on your amplifier whether or not the impedance will be an issue. You are correct that adding the Super Tweeter can drop the impedance very low. Usually, this is somewhere in the 3 ohm range, but is does also depend on the impedance curve of your speakers. With most speakers, the impedance will be above the nominal rating when getting into the higher frequencies, so it should not be as much of an issue in that case. Overall though, because higher frequencies require less power, there will be less draw in the Super Tweeter operating range. But, if your speakers impedance drops below 4 ohms above 10k, that could potentially cause problems as your total impedance would drop below 2 ohms. So again that would be a spec you want to check on the amplifier side.

How do you connect these super tweeters to Bose 901 Speakers that use the Equalizer?

In the past we have not recommended to use the Equalizer with the Super Tweeters because if you boost the signal too high it can damage the super tweeter. To connect to the Bose 901, you can just wrap the raw wire around the terminals, and be sure to make sure the copper strands do not touch. Thank you.

Loudspeakers is 4 ohm, pair with this super tweeter's 4 ohm connection makes the resulting 2 ohm impedance. Would this causing amplifier to breakdown

It depends on your amplifier whether or not the impedance will be an issue. You are correct that adding the Super Tweeter can drop the impedance very low. Usually, this is somewhere in the 3 ohm range, but is does also depend on the impedance curve of your speakers. With most speakers, the impedance will be above the nominal rating when getting into the higher frequencies, so it should not be as much of an issue in that case. Overall though, because higher frequencies require less power, there will be less draw in the Super Tweeter operating range. But, if your speakers impedance drops below 4 ohms above 10k, that could potentially cause problems as your total impedance would drop below 2 ohms. So again that would be a spec you want to check on the amplifier side.

Can I use this with its own amp or is it required to tap of your main speakers through their binding post and it’s amp.

I use them patched into the posts on my mains. I didn’t notice them sucking any noticeable power away from the mains. I set mine on 16 KHz -2db setting while listening to vinyl LPs and like what they add. If you can dedicate an amp to them, good for you! I can’t think of any barrier you’d encounter.

Audio Driver Type	Planar Magnetic Driver
Tweeter Diameter	9.8 Centimeters
Is Waterproof	False
Color	Aluminum Black
Speaker Type	Tweeter
Controller Type	Corded electric
Additional Features	Customizable Audio
Control Method	App
Warranty Type	Limited
Speaker Size	5.25 Inches
Audio Output Mode	Stereo
Antenna Location	Compatible with speakers which have a sensitivity level between 85-96 dB, For 2ch Stereo Sound Setup, For Home Theater System
Enclosure Material	Aluminum
Mount Type	Top on Speaker
Specific Uses For Product	2ch stereo sound system, Home Theatre, high-fidelity audio playback
Speaker Maximum Output Power	100 Watts
Compatible Devices	Projector, MP3 Player, Laptop, Desktop, Television, Tablet, Smartphone
Item Weight	3.5 Pounds
Item Dimensions D x W x H	5.1"D x 4.9"W x 6.9"H
Connectivity Technology	Bare Wire, Speaker Wire With Banana Plug, Spade Connector
Subwoofer Connectivity Technology	Wired
Frequency Response	40 KHz
Impedance	4 Ohm
Is Electric	No
Power Source	Corded Electric

DST

Details

Beschrijving

Specificaties

Veelgestelde Vragen