YZHIDIANF Pre-Programed Tire Pressure Sensor for:-Ford Explorer 2006 2007 2008 2009 2010 F150 2007 2008 Edge Escape Fusion for:-Mustang for:-Lincoln MKZ Navigator Mark LT TPMS 6F2Z-1A189-A 315MHz (4)

Works great.

Very good product. Preprogrammed for my truck. Tire shop installed as instructed not to program, do not scan. A block away from the shop the monitors warning lights went out.

Not sure what is going on, the TPMS light was off for about ten minutes of driving then came back on. Been on since. Tried to reprogram again this last weekend 10/29/25 and still nothing. Not sure what is going on. Sensors show to have good batteries but won't connect to 2012 Nissan Rogue?

Ordered the set of 5 for my 2016 Jeep Wrangler. I took these to a local tire shop to have installed and they have worked great since. Much more cost efficient to buy these than at the tire shop. So far they seem to connect great and have not caused me any issues. Even made my tire light go off. I only had these installed a week ago but have not had any issues with any leaking or failing yet.

worked out of the box without a need of programming. 2016 ram 1500.

Make sure you read all the fine print to see that they are compatable with your vehicle. I missed the years they worked with Chrysler products and they would not program to my car. Other than that they were great. They appeared to be a good product. And, they were certainly reasonably priced.

It works perfectly fine on the Lexus LX570 replacement. The only issue it came with 4 sets, and I have a spare wheel that requires 1 as well, so I bought two sets. It would be nice they could offer five set in one box all same brand. Activation was easy

I purchased a 4 pack for the 2005 Grand Cherokee. Just deflate the tire, break the outside bead, reach in and hold the old one, loosen the retaining nut, DON'T DROP THE OLD ONE WHEN REMOVING IT, install the new one without dropping it, the retaining nut and the metal washer go on the outside, tighten the retaining nut fairly tight, you can only go "tight enough" because you have to hold the sensor in place without it rotating and hitting the rim, DON'T OVER TIGHTEN OR LET IT WEDGE AGAINST THE RIM OR IT WILL BREAK. Refill the tire to the recommended pressure, you probably need to lift up on the tire to seat the outside bead against the rim while airing it up. You definitely need a helper for this, but it is definitely a DIY project. For the Grand Cherokee you need to drive it over 20mph for about 10 minutes and the computer will program itself to the new sensors.

Bueno producto sin tema pude remplazar los viejos sensosres

I bought this product for my Ford Taurus 2010. Amazon said it fits my vehicle. I went ahead had the technician installed them in my tires. They weren't recognized by my car, so I went to a car computer technician to program them. I WAS TOLD THIS IS NOT SUPPORTED BY MY CAR. Amazon wouldn't refund me until I return the product. Unfortunately, installation fees and removal fees would cost more than the product price. So a complete loss for me.

Se instalaron en toyota corolla 2010 y excelente funcionamiento.