iSonic P4820-WSB25 Commercial Ultrasonic Cleaner with 25-min. Timer, 2.6Qt/2.5L/White Color, Stainless Steel Wire Mesh Basket, 110V

Following the directions printing on the bottle, after 15 minutes in the ultrasonic cleaner, the 45acp casings looked new - there was no carbon or primer burns either inside the brass or in the primer pockets.Afterwards, the washing with clean water was straightforward without complications.I was so impressed with this product's results I decided to re-clean casings that had been "cleaned" with a different manufacturer's product.The results were startling. Using the recommended 1:40 ratio, the iSonic CSBC001 made the already cleaned brass significantly cleaner-brighter When finished, the solution in the ultrasonic tank went from clear to murky - and this, I repeat, was after cleaning brass casings that had been previously cleaned with a different brass cleaning solution..This product deserves 6 stars and I'm definitely re-ordering iSonic CSBC001.

My AMAZON RATINGSProduct as described. nicely designed unit. Corroborator parts come out very clean, looking like a new part. I used Simple Green 13421 Pro HD Heavy Duty Cleaner and water mixture.Pros:+ product as described+ photo as Shown+ Good quality+ Parts come out very clean.Cons:- None-- How I rate –5 Stars:Works exactly as advertised, is a good value at the price point purchased, would buy again or recommend to a friend.4 Stars:Works exactly as advertised, fit/finish are what you'd expect when purchasing this type of product, might have a minor flaw.3 Stars:Generally works but it may not be a good value at the price point or might like to see changes / improvements.2 Stars:Barely works but can be made useful if you try.1 Star:Useless, does not perform its intended function whatsoever and is generally a waste of money, sending it back.Overall: I am giving this my star rating based on my criteria above.(Product photo as received)if this review was helpful let me know. Thanks :-)

This little basket fit perfectly in the ultrasonic cleaner my husband has. I got it to replace the basket that came with his cleaner. It is very heat durable. Actually helped knock the brass noise level down. Made all his cases come out sparkling clean.

This ultrasonic cleaner works very well, especially when the correct solution and temperature are used. I have been using it primarily for cleaning brass shell casings, along with the RCBS case cleaning solution. My result has been like-new brass with just two or three 15-minute cycles, with the heat on and a few minutes of soaking between cycles. It's more powerful than a lot of ultrasonic cleaners out there and is simple to operate. It's not too loud, either. I'll be using it for all sorts of things in the future. My one complaint would be the lack of a drain valve, as emptying the tub can be pretty messy if you don't do it right.

worked perfect, just like the one I bought 5 years ago.

This is a perfect fit for my Harbor Freight Ultrasonic Cleaner.

Wow for 9mm brass cartridge case cleaning. My 9mm brass looks like new! Clean inside, outside and even the primer pocket is shinny. Used directions on bottle: 40:1 mixture, rinsed cartridge immediately after cleaning in a HF ultrasonic cleaner. I also rinsed the ultrasonic cleaner and wiped dry with a towel. 2 ½ cups of tap water and 1 ½ tablespoons of this CSBC001 solution which just barely went over the minimum mark in my cleaner. 3 - 480 second cycles later I had over 75 perfectly cleaned 9mm brass. I did warm the solution up to around 125-130 degrees in my microwave and then used the heater function on my HF cleaner off and on to keep temperature in that range during the 3 cycles. Used a HF laser temperature measurer to check temperature. Perhaps next time I will poor the solution out after only one cycle and see how they look. Kind of hard to pull the HF short basket out of hot water, so poured the solution out of the cleaner. Very impressed with this solution. I first tried tap water and dawn dish soap and was not happy with the results. Will buy more of this when I run out.

This unit cleans the brass cases fairly well, but they are not polished like a tumbler does. You have to run it 2 or 3 times to get really dirty cases clean (like the nasty ones you pick up off the ground at the range). Also, even though the cases are clean, they tarnish almost immediately after they are rinsed off. I guess that's no big deal and will not affect the loading process or accuracy. It could also be due to my well water even though it is run thru a softener. If I could find a rinsing solution that would leave a tarnish-resistant finish, it would be great!I found that a solution of 1 qt. hot water, 1 cup white vinegar, 1 Tbsp salt, and 1 Tbsp of liquid dish soap or Simple Green actually cleans the brass as well or better than the included cleaning solution. And, it's a lot cheaper. I found this formula on one of the shooting forums on the internet, so I do not take credit for it. The unit appears to be well made, and comes with a stainless steel basket and the cleaner solution. It's easy to clean out after use. It is reasonably quiet. I noticed that this same unit is marketed under several different names, including Lyman. It's also marketed as a jewelry cleaner, but with only a 4 minute timer, so be careful that you order the brass case version with the 25 minute timer. If an ultrasonic cleaner is what you want, this is a pretty good one for a reasonable price.Durability is still TBD, as I have only cleaned about 400 .38 Special cases so far.