Inline Fuse Holder 12V 2 Pack, Extended Version 10 AWG Waterproof Fuse Holder 13.8 Inch, in Line Fuses Holders 12V with 2 Pcs Standard Car Fuses 40A Blade Holders for Automotive, Marine by XIOGZAXI

I needed something for a robot project, and this is perfect. They held up to the solder and run fine so far. No blown fuses and no shorts. If this runs for another year or two without any issues , I’ll say that it’s pretty good quality. My only concern is that it’s cheap and will shirt out sooner than later but, o ly time will tell. So far, it’s a great product .

I was very pleased with the inline fuse and it is comforting to know that it is seal so well and it feels and works as it should and is high quality made and the fuse holder is tight secure and has no signs of being cheaply made.The installation was ease you just cut and splice it in where it's needed and it looks very nice and high end and reassuring to know that it is protecting my electronics on my machine.

This is great. It's exactly as described and comes with a fuse. I used it to wire a LED flood light on an ATV directly to the battery from the switch. I just replaced the fuse with a 10 amp and soldered this on to my wire close to the battery, and put a battery connector end on it, and works great.

Good fuse and holder for 12-v system. Works fine on my running light on Polaris

Heavy gage wire and includes 40A fuses as described.Wire is long enough for most splicing and connection without issue.Very good quality molded fuse holder and is water-tight when closed.

Great product and price along with customer service

Works great....be sure to use heat shrink on fittings. Motor ran like always.....was not volt. regulator or stator after all....just blown fuse caused battery not getting charged. But it came with 30 fuse, not 25....like I thought.

Nice holder, solder - Liquid Electrical Tape and shrink tube = sealed