Mighty Mag Magnetic Base, Made in USA Caliper and Indicator Accessory

Works like a champ, great product

Vey strong magnet. holds tools great. no problems.

I have only used this a couple of times so far, but it is very, very useful. As a woodworker, often I need to sneak up on the fit. For example, I had a tight dado. I measured the dado and the insert board with calipers, calculating the difference. I then used the mighty mag to hold the digital gauge against the saw fence, so that I could "bump" the fence the exact adjusted amount on the first try. This saved me time AND prevented me from going too far and ruining my piece.

The magnet holds nice and strong, and it is handy in a few situations, but I haven't been able to use it in as many areas as I'd hoped. It does work well for holding an indicator on the ways for measuring carriage travel on a lathe, but you'll want to add some tape to the underside as the edges are quite coarse, and can ding up the ways if you're not careful. Speaking of coarse edges, I had to chase a few of the threaded holes with a tap in order to get the screws to go all the way in. Not a huge deal, as most folks getting a dial indicator holder will also own a few taps. But still for an american made product, I was hoping for a little better fit and finish, so I had to ding it a star

Its a bit pricey but you get what you pay for. It lives up to its name. Stays put everytime. Really the only complaint i have is trying to get it up off the steel.

High quality, very happy with purchase

Was cleverly misguided when looking at this item. The magnets sit long ways on edge instead of flat causing it to obviously be weak and give false reading values in critical environments. It will do in a pinch.Verify rear flywheel housing centricity X15 transport engine, what a pain.

It’s perfect. Had one for years and lost it over time. This is new with both holder holes. Buy it.