2 in 10 out terminal blocks

Didn't use them on a DIN rail so can't attest to how sturdy that setup is, but it worked great for splicing the home run wiring on 24V LED lighting systems.

I worried about this being an unknown brand, but subjected it to a few retention tests and all is well. I should probably do some tests with large loads, but it's been very reliable with all my +5 and +12 low amperage needs. It is an integral part of the power distribution in a machine I built, and was a huge improvement over the ancient barrier strips that I had been using before. They are easy to use. Would buy again. Photo shows a polycarbonate subpanel that made it easy to handle as a unit in the available space (a 5 volt supply lives in that cut out area)

Seems to work well hold the wires in place.

Works good

I love these, I use them all the time

Working well in my 3d printer to split out the AC to dual PSUs and AC bed heater SSR.

Worked great!

I work for a manufacture of processing equipment so I am always building some sort of contraption to demo products. I stumbled across these and ordered some as I use a lot of lever nuts in my builds, they're quick. These allow me to land and bridge out two connectors multiple times and keep the polarity separated. pretty handy when needing to make a small DC branch or bus. Highly recommend these.