Fasgear PCI-e 5.0 Extension Cable,16Pin(12+4) Male to PCI-E 5.0 3x8Pin Female Sleeved Extension Cable with 4 Cable Combs,30cm 12VHPWR(12V-2x6) Cable for GPU 3090Ti&RTX 4080 4090 5070 5080 16AWG

Great quality and very sturdy cable. Tested with Asus TUF RTX 4090 and no issues whatsoever. Recommend for a clean setup.

Needed replacement for spider like cumbersome nvidia adaptor. Works fine with 300w and my 4080 FE. Definite click when plugged in. Would double check using with 4090 due to power required on load.

i ordered this adapter in case of a wide rtx 4070 ti, but the pny one i ended getting had a receded 12vhpwr connector by 2cm and that left enough room for bending the original adapter in my narrow pc case which is has a clearance of 165mm, the card is 137mm wide, which left me with 48mm space, enough to bend the original adapter. i will keep the fasgear for any future need.

Using this in conjuction with a Fasgear 90 degree adapter with a Strix 4080. Was terrified of using these new 600w cables or adapters due to the rampant horror stories about melting etc. Fortunately my fears about this were totally unfounded. Card is working perfectly with no issues. Nor my cables or my 90 degree adapter are hot to the touch. Yay:)

Whats to say it does what its suppose to and tidies up them unsightly pc cables and fits nice without to much of a bend.Really pleased with this purchase

My geforce 4070TI card came with a faulty 12v power lead which seems to be known issue on the graphics card and this cable worked a treat to get the graphics card to power up and boot

I couldn't make the pcie connections engage. I applied for a return/refund which was granted. As a last resort I examined the connectors. In each of them (all 3) there was one bent pin. I straightened them and got connections. It must have been put together on a Friday afternoon. I shall cancel the return but one wonders about quality control.

Ok i bought the 3 x 8 and 4 x 8 cables to see if both allowed a full 600W on my Asus TUF 4090. While the 3 x 8 works fine and pushed a full 600W to the card, for an extra couple of quid it might be worth going for the 4 x 8 as 600W split between four plugs will probably be better than three if you are running a 4090 with a 600W bios. For less powerful cards or those on a 450W Bios then this 3 x 4 pin is ideal and significantly better than the supplied nightmare Kraken of an adaptor.

En remplacement du câble d’origine pour une RTX 3090 Ti supprime X 24GO, gain de place énorme, câble management optimisé beaucoup plus joli et surtout fonctionnel.

Super Kabel, schöne Länge, genug Saft für eine RTX 4070 Super

RTX4080に繋げました。 FF15ベンチ4Kで回して問題なく動作しています。

Buscaba un cable más flexible que el de serie de las 4080 gigabyte, y este ha cumplido perfectamente y facilita el montaje de las mismas al ser más largo que el que se proporciona por defecto. Otras marcas conocidas lo venden al doble de precio, pero el cable se siente de calidad y ha ido perfecto.

I have 2 days using it and so far no melt. The cable seems to be very well made, beautiful installed and the cable management was very easy with it, it’s long enough. I had inserted a Corsair temperature probe on it just to be safe. There is a small gap on the cable sensor with the GPU, it’s impossible to connect it tighter. However the power cables are absolutely no gap at all. Under load the voltage drops to 11.950 or 11.890v minimum. So seems to be safe. I will be using it until my cablemod arrives. If it melts I well came back here.