eoocvt M3-M6 Adjustable T-Handle Tap Wrench + 4 pcs M3 M4 M5 M6 Machine Screw Metric Thread Plug Taps Set + 4 pcs Drill Bits Set

For 10 bucks you can't beat this. I received it and went right out and tapped two holes in my bike frame using the corresponding drill bit and then the tap. Work perfect. I don't know what these other whiners are talking about but for less than $10 this performed like a more expensive set. If you're handy you won't have any of the experiences of these other knuckleheads . . ,this is going down as one of the best buys on Amazon for me.

Average is good for me, it's exactly what I needed. I've used over a few dozen times already all successfully. Still sharp and going.Look, for the price you really shouldn't expect greatness, you should already kind of know what you're going to get.I will say these have been on the good side. Just go slow and straight and you are golden. They should get you through any job.

Needed a basic metric tap set. I do 3d printing and light work with soft metals. Much better than trying to create tolerance inside CAD for the hole. If it doesn't require a ton of force then screwing it in makes it much easier to assemble.

Bits work. Handle literally unusable. Does not tighten enough to keep bits from free spinning in even soft plastic.

There are a lot of complaints about this not fitting the smaller taps, but there are TWO sets of teeth inside the handle (just have to push down further) and then you can use the smaller taps.There are no instructions stating so.

These are useless. I was trying to tap a M4 hole in some soft bronze, and couldn't even get the drill bit to bite to enlarge an existing hole. The tap was even worse: the tapered end of the tap was so dull that I couldn't get the tap to grab in the soft metal. Totally dull . And for the record, I know what I'm doing and regularly tap holes in steel and stainless steel. I used the proper cutting fluid and even used my own tap wrench which is of higher quality (the included tap wrench does work, btw - it has a multi-depth chuck to grip the smaller taps). I was hoping to have an inexpensive set of metric taps for occasional use but couldn't get a single use out of this. I recommend you look elsewhere.

actually should have got this long ago. Comes in a nice square box to keep all the bits in and the quality good enough the threads did not ware down after about 6 used to add some stand offs to a heat sink and some holes for mount screws

Bought these to help with builds on my 3d prints. Great for tapping holes in my builds. Have also used on some steel and aluminum parts. Works great.