Evolution Power Tools R255SMS+ PLUS 10-Inch Sliding Miter Saw Plus Multi-Material Multi-Purpose Cutting Cuts Metal, Plastic, Wood & More 0˚ - 45˚ Bevel & 50˚ - 50˚ Miter Angles TCT Blade Included

As advertised and works well with wood and 1/8" metal, will be cutting 1/4" later but I suspect it will cut it fine as it cut like butter on the thinner metal . Does not make much noise when cutting either.

This is a great saw! I don't normally write reviews but I did for this one. When I recieved the saw the left adjustable fence was slightly warped from manufacturing so I contacted evolution customer service (which I got through within 30 seconds!!) and the rep was great got the replacement part sent out right away! I do recommend if you're going to be cutting metal with it to fab up a small cover for the laser since the placement of it is right in the cuttings path. Also I ordered a mild steel cutting blade since the reviews on their all purpose blade didn't bode well for extended use. I've been cutting 2x2x0.25 and this thing cuts through metal like butter and it's consistent just let the saw cut and don't push it hard. Definitely wear arm and face protection since, like with any cold cut saw, it shoots off a lot of tiny metal cuttings which can hurt. I've used it to cut different hard wood as well, I didn't bother to take off the steel blade and it cuts through walnut, ash, maple and red oak very well with minimal chip out. All in all if you're looking for a one stop shop compound miter saw this one impressed me!

Su trabajo deja sin palabras

Great general purpose miter saw - works for trim and steel alike! Two things to keep in mind: 1. Take it slow when cutting metal, you don't want to jam it down and have the teeth grab instead of cut. Best case you just stop the saw, but you can chip a tooth, or worst case it throws bits of the blade around. 2. It's good practice with any saw, but make sure to clamp down you material, especially if it's metal. This saw is powerful and can throw small pieces way harder than you think... ask me how I know...

La compre para trabajos caseros, definitivamente tenerla te anima a querer hacer todo tipo de cosas ya que corta de todo. Estuve cortando PTR cal14 como si nada, cuadrados sólidos de acero perfecto, hasta que intente cortar unos ángulos que desde un inicio sentí el material más duro el filo de el disco se fue con pocos cortes. Simplemente necesito más discos, pero maquina muy recomendable