Tactical Index Clips, Weapon Light Pressure Switch Cable Guides,30 Piece Set

Absolutely clutch. I had doubts they would really work to retain the flashlight cable, but it works great, and they give you plenty to fill a whole hand guard if you needed to.

These tactical clips are of very good build quality! Literally, to get something tougher than this, you'd have to make it out of steel!

These insert well and clip tight. Real easy to install. They are plastic with texture. Not sticky so not much good for wet environment work. I’d say light to medium duty, and average quality. They do however fill in the rails as stated.

These work fine. They COULD break if you try to superman them on. If you take a dead blow hammer or rubber mallet, clip one side on, hit the middle of the clip, (not hard! But firmly) It will click and seat out. They look good and hold the wires down fine. I used the back (handle) of a screw driver to push the wire into the clip (for the outside clip holder) to keep from marring or cutting the wire. Great value. If you need to remove them use a tiny flat head screw driver to gently pry off one side of clip.

Fit is tight, not slippery. Work well.

If you are buying these for a firearm, I would definitely just get the LaRue tactical ones. These ones have sharp edges and feel like cheap Chinese rip offs.

A little hard to install at first but after a few they make cord management a breeze.

Uncovered Picatinny rails can be uncomfortable to hold and securing light cables to a firearm can be a challenge. This product solves both problems with a quick, effective and economical solution. Thanks to Tang Creations for a job well done!