2-Pin 8mm COB Strip to Wire Connector Unwired Clips Solderless Adapter Terminal Extension Connection for High Density LED Strips Lights 12V 24V (Pack of 10)

These crimp on connectors for LED strip to low volt wire (I used 18 ga to connect to 8mm COB LED strip) are infinitely better than the screw down connectors. You don’t need to strip these insulation on these unlike the screw down. My LED light was occasionally turning off until I replaced every connection with these, now it’s solid.Watch the video in the product images - it’s super helpful for how to align the “teeth” with the copper pads. These are easily hand pressed while the other wire side requires a hand tool to clamp tightly to lock the little clear tabs on the side.

I installed two different sets of COB LEDs using the 8mm Biantie connectors, and didn't have an issue with ANY of them. SO much better than my previous experience with LightingWill connectors, which always suffered from intermittent connections.One thing - Biantie says that the connectors can be pried open with the proper-sized screwdriver. That's a true statement, but what Biantie DOESN'T mention is that just because you can reopen the connectors DOESN'T mean that the connector can be reused after it has been "unsnapped". The tiny plastic tabs/nubs that lock the connectors in the "closed" position have a tendency to shear off when the connector is pried open, meaning that the connector won't lock "closed" again.

Like:Don't need pliers to firmly connect to LED strip or wires. A simple pressure by fingers does the job.Dislike:Some of the parts get closed in the package. Hard to open them lip for attaching to LED or wires.

If you knew to buy these you probably had a good idea of how to use them but without instructions the first thing to is figure out orientation. They show pictures of the two folding sections for the wiring and the LED strip but don't make it terribly clear that the folding sections are down toward the backing side of the LED. I would also want to insert the LED fully into the housing but then the spade in the connector wouldn't press into the center of the pad on the LED so I don't really know if I truly connected them the best but they do work. It does need 22 gauge wire as if you drop any smaller it will not bite into those and stay connected.They are working so far and were pretty easy to install.

Bought these connectors because a different connector caused the lights to flicker, this connector works great. Gets a perfect connection and doesn't cause the lights to flicker.

Total crap. Tried eight different connectors on my 8 mm light strip. Followed precise instructions. Got the extension strip to blink on once and then never again. Kept cutting and re splicing cutting and resplicing. Total crap. Do not buy

used them for my auto LED lighting kit and they worked great.

They work well enough, and if you trim the LED strip correctly, leaving plenty of copper to grab, they capture that edge well. But your copper conductor on the other side will barely grab and stay secure. Needed plenty of electrical tape and heat shrink to make these solid enough to maintain the connection. Would love to see a re-design.