Helunsi Cabinet Door Lamp Switch, 2 Pack for Closet Light, ON Off Normally Closed Wardrobe Touch Activated, for Open Close Sliding Pressure Doors Drawers Automatic Switch - White

Used one of these to actuate led strip lighting in a pantry so the lights turn on and off with the door. Works great -- the soft close mechanism of the door hinge hardware is strong enough to press these switches.

Compared to other door switches sold on Amazon, this one is much better quality and reliability. It operates flawlessly and has a positive click action that indicates when it is opened or closed. I mounted it near the hinge side of a closet door. I will say that it is bigger than some others. The mounting is very straight forward. Wiring for the 12 volt, 18 gauge wire in my system was fairly easy, but the screws on the terminals will fall out if they are turned out enough to let you wrap the wires around the screws. The terminals do seem very secure. I needed to cut a bit of plastic with a wire cutter to allow the wires to come out from the terminal area. This was no big problem, but good to know. I measured the resistance when closed and found it to be extremely low and consistent. Overall a good value and very reliable compared to some others.

I installed these in lower cabinet running a 24v led strip system. The hardest part was figuring out where to mount it so the doors would contact. Both work and perform exactly as I hoped. I would absolutely recommend and would but again if I need. 1star off because instructions should specify in/ out or explicitly say it doesn't matter. I put the hot in on the screw furthest away from the spring mechanism. I did not have problems.

Perfect for my closet & pantry lights Installed four months ago & work every time the doors open. Quality product

The cabinet switch performed exactly as anticipated. It was easy to install and wire

Did this a year or two ago and it works fine each day. Have an armoire that always has been hard to see into. Repurposed a three-bulb portrait lamp to light the cabinet. Not using middle bulb - too bright. Much caution if you're not handy. Mounted lamp way on top. Pilot holes needed. With left door open and right door (switch side) closed, held switch inside and pressed it forward to the right door until it clicked, ie, light off. Marked the wood with yellow wax marker. Drilled a half inch hole behind yellow line. Took a new regular extension cord and cut it a foot from the three-outlet end. Stuck both the long and short ends of the cut wire down through the hole in the cabinet top. It was unwieldy reaching up kind of inside the cabinet, but stripped the wires and attached them to the four terminals in the switch. Pay attention to keeping neutral and hot wires consistent. Aligned switch in front of yellow mark. Marked mounting screw holes and drilled pilot holes. Reassembled and attached switch, feeding extra wire up the 1/2 inch hole. On top of cabinet, lamp plugs into extension cord end like it would anywhere and long end drops behind outside of cabinet to outlet.

Works great, easy installation and great deal

I found these switched to be exactly what I was looking for for the storage room project I was working on. Just attach some wires and place the switch where it will open the circuit when the door is closed and close the circuit, turning the light on, when the door is open. Keep in mind there is an audible "click" when the switch is engaged, about the same volume of a pull chain light. Just FYI. Just read the directions and become familiar with the pieces before you start the install, and be sure the power is shut off. Safety first. Overall I think anyone with even basic home improvement skills could use these and find plenty of uses.

Used it in my red sea aquirum cabinet on a 12v light bar works great.

J’ai utilisé cet interrupteur pour ouvrir/fermer le circuit électrique pour des lumières dans un vaisselier. Le ressort de l’interrupteur force la porte du vaisselier à s’ouvrir sous la force de ce bouton.