Antrader 2-Pack 12mm x 32mm x 10mm 6201Z Double Shielded Deep Groove Radial Ball Bearings

Very good bearings! Love the smoothness and feedback from them. Wish they offered bigger packs.

Amazing, for the price, low friction 608 bearings. It can be difficult to find decent low fiction bearings in any price range. I've purchased a ton of them from different suppliers and most of them are far from low friction. Not to mention many companies call their bearings low friction when they're full of grease that causes a lot of friction and if you clean the grease out the tolerances are pretty bad and they vibrate when spinning at high speeds. Would I put them in a skateboard, no. They're not sealed and I don't think that's what they're designed for even though they could probably handle it for a while. Anything that doesn't take a severe load and needs to be very low friction, yes I would use these and do. They work great for low load conveyors, almost too well for a lazy susan, fidget spinners work great, they also work well in low friction 3D printing spool holders. I've yet to receive a bad one. I hope the company can keep up this level of quality and I'm very surprised this doesn't have more reviews than it does.

Who knew skateboard bearings were a perfect fit for a bandsaw? I purchased a secondhand Grizzly bandsaw that had been neglected for a while. Apparently, someone had set a paper cup of Coca-Cola on the cast iron table and forgot about it. For a LONG time. cup dissoved, acid at into the cast iron, and ran down into the set of guide bearings. The table I was able to get back to 90% original, but the bearings were seized. Grizzly very proud of a set. These were the exact same bearings for less than the shipping from Grizzly. Perfect fit and function. And with this set, I have spares left over!

I use these in our wind spinners and they fit and work great. Here in the desert they hold up well during the dust storms and are a great replacement for the plastic ones that sometimes come in the new spinners .

I use these for 3D printed fidget spinners, they seem to work pretty good but don't spin as long as I would have hoped. They also don't seem as smooth as some other bearings. For the money, I've been happy with them and I have purchase more since the original purchase.

I bought as a replacement, and it fit perfectly.

I needed these for a 3D printing project. I've gotten others that don't allow for spinning but these are great! They go for a while without any weird smells or greasy feeling. Super satisfying for fidgets.

These things spin like crazy. They seem to be good quality and worked beautifully for my project.