iGreely 5.5mm x 2.1mm DC Male Power Plug Cable for Portable Generator 14 AWG Wire 3.3ft/1m (Male)

I use this cable to power my Starlink mini dish with a 20Ah 12V LifePO4 battery. On the battery I have an Anderson Powerpole connector. I connect the Anderson Powerpole connector on this cable to my battery and then plug in the other end into the Starlink mini. I have not had any issues using this cable. It does not get hot and it looks well constructed. Each of the connectors have shrink wrap to protect the connection. If needed you can pull the cover back to adjust the arrangement of the Anderson Powerpole connectors to match whatever you are plugging them into. Some are vertical whereas other devices accept the powerpoles horizontally.

Worked perfectly for my purposes. I used this adapter cable to connect a set of portable solar panels to my Rockpals 200 watts portable power station. I actually felt a little bit stupid because when I first tried to hook it up, it didn't work. I thought I had a male-to-male connection, and that I was out of luck. But then I remembered reading on a site that these Anderson connectors can be reconfigured so you can move the black and the red to a different horizontal positions, or even stack them vertically. It's hard to describe, but when you see them, they're kind of like Legos. Very cool.

Item was as advertised. Used for solar input recharging on a portable power station. Performs as expected.

This is a nice cable that works well to connect my solar cells to my equipment with Anderson PowerPoles. Easy to install and work with, now if I can stop misplacing my cables.

This is a solid, well made cable to connect Anderson Powerpole connectors to a 5521 plug, useful for connecting Powerpole-equipped devices (like ham radios) to a power station. The glitch is the arrangement of the Powerpole connectors. The standard in ham radio is for the connectors to be side-by-side. For some reason, the connectors on this cable are stacked top and bottom. (In the photo, my radio's connectors are on the left, the default arrangement of the cable is on the right) If you know how to work Powerpoles (and if you're buying this cable presumably you do), it's easy enough to take the connector apart and rearrange them. I wish I had read the comments about this cable before I bought it; it would have stopped my annoyance at the cable not working the first time as I expected. Still, a good cable and an easy fix, if you need to.

I purchased two of these and they were exactly the same, 100 cm tip-to-tip. The 14 AWG wire will handle 15 amps and have less than a 2% voltage drop at 13 volts at one meter. Thus, not a problem if only pulling 10 amps at that voltage. I plan to use these with 12v LED flood lights that draw less than one amp and provide 800 lumen (60w) of light each. You do have to adjust the power poles to be side-by-side which is not a problem. * I purchased two of these to use with my Ecoflow Delta 2 DC5521 three amp ports. While both DC5521 barrel ports are three amps simultaneously, they are shared with the 12v vehicle charger port of 126W max all combined. Basically, if you're pulling 10 amps using the 12v vehicle power port, there's nothing left for these two ports. If you do plug something in, you'll have reduced voltage and amperage and that can be very bad for many devices.

And this one works fantastic. A couple of months in the car with zero problems.

Measurements and size are dead on. Good solid Anderson connection. Barrel jack fits Celestron and Orion telescope equipment well.